MakerBot Replicator Disassembly Manual

MakerBot Tools Needed: 1.3mm Hex Driver T10 - T20 Torx Driver 2.0mm Hex Driver 1.5mm Hex Driver 2.5 mm Hex Driver Pair of thin Tweezers Small Container for Screws Color Guide: Button Heads Screw Action Thread Forming Screw Socket Cap Screw Flat Head Screw ...

Removing the Gantry Removing the Brooklyn PCB Removing the Z Stage Case Disassembling the Housing Disassembling the Z Stage Removing the Belt Disassembling the Gantry Removing the Carriage Removing the filament Spool Drawer Removing the Top Cover Removing the UI Disassembling the UI Disassembling ...

Spool Drawer Remove the six (6) thread forming screws that hold the Spool Drawer Alignment Brackets to the Z-Case. Pull the Filament Spool Drawer upward to remove from the body of the Replicator and set aside. Step 1 - Remove the Back Panel Six (16) Button Head bolts Remo ...

Remove the thread forming screw attached to the grounding cable from the UI. Remove the four (4) thread forming screws holding the UI Electrostatic Discharge Cover (ESD) cover onto the UI Faceplate. Pull apart the ESD to separate. Remove the four (4) thread forming screws that attach ...

screws attaching the Carriage Assembly to the Carriage Adapter. Note: This step only necessary if you troubleshooting the LCD screen or Hoboken PCB Gently lift carriage upwards and wiggle to unsnap from the carriage mount. To disconnect the LCD Screen lift the brown tab on ...

screws attaching the motor to the Carriage assembly and set motor aside. 6 MakerBot Replicator MakerBot MakerBot Replicator+ Remove loosen up the set screw holding the castle nut on to the motor axle. Remove the two (2) silver thread forming screws attaching the Extruder Fan to the fan mount and set aside. Remove the two (2) s ...

attaching the X Gantry Extrusion to the Y Gantry Extrusions. Repeat for both Left and Right Y Gantry Extrusions bracket. Remove the following screws: Using a 2.0mm hex driver loosen up the shoulder screws to remove the Idler Pulleys. (if needed) Remove the two (2) socket cap screw ...

remove the Electrostatic Discharge Cover (ESD). Remove the two (2) button heads using a T20. Remove the one (1) button head attaching the PCB Adapter Plate to the Base Plate. Gently lift the ESD cover and unplug the WiFi Antenna. Next open the white cable clip located on the top of ...

on the front of the printer on the Two (2) Buttons heads that attach the Floor plate to the Base Plate (inside the Replicator+) using a Remove the following screws: Pull the Floor Plate away from the front of the Replicator+ to remove. Remove the seven (7) thread forming screws ...

attaching the Z-Motor to the Z-Back and turn threaded lead screw to remove from Z-Stage. Remove four (4) socket cap bolts attaching Z-Nut to the Z-Stage . Step 15 - Remove Z-Motor and Z-Nut ...