Midmark 224 Installation Instructions Manual

MA10643i Screws Tabs 224/225 Main PC Board Installation 224 (002-10083-00) 225 (002-10083-01) 003-10091-00 Rev.AA2 3/19/19 Step 1: Remove Top Cover A) Position chair to approximately 21” from the top of chair frame to floor. B) Unplug ch ...

MA10644i Step 2: Remove Side Cladding. A) Locate tabs inside at center of chair (foot rest must be extended). Push down on top tab and up on bottom tab. Pull cladding away from chair. B) Pull up on Cladding overhang, and remove. C) Repeat process ...

MA10646i Step 4: Remove front drawer A) Remove Retaining Screw. (located on one side only) B) Push LH side lever UP and RH side lever DOWN. C) Remove drawer by pulling straight out. Note: Side levers are clear plastic Step 3: Remove Rear Claddin ...

MA10647i Back Tab Equipment Alert If the chair is at a height where the inner shrouds are being lifted/supported by the outer shroud, care must be taken to secure the inner shrouds while removing the outer shrouds. Front Tab Step 5: Remove Outer Shr ...

MA10649i MA10648i Inner Shrouds Step 6: Remove Inner Shrouds. A) Remove screws from head-end & foot-end of Inner Shroud B) Pull Inner Shroud away from chair to Remove. Repeat on remaining Shrouds. Step 7: Remove Control Board Housing Cover A) Re ...

Equipment Alert When installing new PC Board, only apply pressure at Standoff points. Failure to do so could result in damage to PC Board. Main PC Board Step 8: Install New Main PC Board & Re-assemble Chair. A) Position the Main PC board on the sta ...