Rhino-Rack RBLW Fitting Instruction

CONTROLLED DOCUMENT Preparing the boat for the eye nuts. Balance point Turn the boat over on to the gunnels, place a roller under the gunnels and parallel to the transom, roll the boat on the roller until the boat is balanced across the roller. Mark the balance point on the side of the boat adjacent to the roller (BP). Front eye nuts position M ...

Transom eye nut position. Transom eye nut positions “D” and “C” generally the position of the transom eye nut: “C” = 120 mm and “D” = 150.0. Drill intersects of, “D” and “C” using a 8.5mm drill. Fitting the eye nuts. Before fitting the eye nuts, deburr the holes and coat the holes with Duralac sealing compound to stop cor ...

Setting up the frame Roof racks and longitudinal bars Note: The Crossbar width must be 24cm greater than the beam of the boat. Fit the three roof racks as per the fitting instruction supplied with the roof racks. The rear roof rack must be fitted no less than 50mm from the end of the gutter. Tighten the rear roof rack. The front and center roof ...

Place the top hat brackets over the longitudinal bars with the channel nuts down into the crossbars. (Refer Diagram). Top hat bracket assy. Longitudinal bar. Roof rack crossbar. ...

Check that the passenger side bar is still parallel. Tighten only the rear crossbar top hat bracket. Note: when tightening bolts with channel nuts, ensure that the channel nut is fully located across the crossbar recess when fully tightened. (Refer Diagram). Channel nut fully located across the crossbar recess. Position the driver side longit ...

Fitting the rope guide peg to the longitudinal bars. Slide the square channel nut into the end of the longitudinal bars to a position in between the front and middle crossbars As per the diagrams. Screw in the rope guide peg. Position the rope guide peg between the front and middle crossbars. Tighten the rope guide peg with the eye vertical. Sli ...

Fitting the Which and Power roller to the longitudinal bars. Winch Assemble the M10 x 20mm bolts, channel nut and washers onto the winch and Z bracket as per the diagrams, ensure that the channel nuts are loose. Z Bracket Assemble the bush and spindle onto the Z bracket, fit the flat washer, screw on the Nyloc nut and tighten. Assemble the M10 ...

Slide the power roller Z bracket onto the driver side longitudinal bar with the roller bush inwards and inline with the winch power roller shaft. Tighten the M10 x 20mm bolts ensuring that the channel nut is fully located across the bar. ...