Rexroth Indramat Mannesmann DKC21.3 Application

ELC and BTV04 Application • 120-2100-B327-01/EN This document assists • in the programming of an ELC via the BTV04 Document designation of previous editions Status Comments Dok-SUPPL*-BTV04*ELW**-AW01-EN-P 08/2000  Rexroth Indramat GmbH, 1999 Copying this document and giving it to others and the use and communication of the c ...

2-1 2.1 The Tasks of a Roll Feed............................................................................................................... 2-1 2.2 The Hardware Needed.................................................................................... ...

AA00 Tasks 2 & 3 ................................................................................................................. 2-18 AA05 Electrical Ventilating................................ ...

selected using the F functions. This makes a quick and secure integration of a Rexroth Indramat system for a functioning roll feed possible (Turnkey solution). For applications with expanded functions, all servi ...

DOK-SUPPL*-BTV04*ELW**-AW01-EN-P 2 Standard Roll Feed 2.1 The Tasks of a Roll Feed It is the task of a roll feed to transport material (sheet-metal, wiring and so on) under a press, cutter or stamper. The material may only be trans- ported if the stamping or cutting tool is open. The synchronisation be- tween feed and press ...

Application DOK-SUPPL*-BTV04*ELW**-AW01-EN-P 2.3 Program Structure in the Control Feed before the Press (Program example) The program sequence of a standard roll feed in the ELC control. The feed takes place before the press hub (feed guides) and the press is op- erated in a single hub. ELC program Block number 0000 JMP 0005 uncondi ...

DOK-SUPPL*-BTV04*ELW**-AW01-EN-P 0015 APE 0 0000000000 outputs (press) switched off 0016 JMP 0009 unconditional jump to block number 0009 0017 NOP 0018 NOP 0019 NOP 0020 BAC 0004 +0000 00010 item counter 0021 APE 0 0000000000 outputs (press) switched off 0022 NOP 0023 NOP 0024 NOP 0025 JST 0000 block j ...

Application DOK-SUPPL*-BTV04*ELW**-AW01-EN-P 2.4 Programming with the BTV04 Note: The DKC programming module must be set to drive address 05. Abb023_BTV_ELW_en.FH7 Barcode 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 H1 S1 S3 S2 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 Rotary Switch S2 Rotary Switch S3 Drive Address set to: 05 Fig. 2-3: Set ...