RED RED BRICK Operation Manual

These batteries have been specifically designed for use with the RED ONE® Digital Cinema Camera and utilize a V-lock mount. PROPERTIES • Robust, water-resistant construction for use in studio and field environments. • Batteries are compact, lightweight, and support high continuous load use. • Sophisticated electronics provide safety protection and optimal performance. • RED EVF, RED LCD, RED PRO LCD display and 5 step LED indicators on the RED BRICK accurately monitor remaining capacity. The battery will shut down if the maximum specification discharge current ...

and workmanship of this RED BRICK battery. We guarantee it to be free from defects in material or workmanship for 90 days from date of delivery or 400 charge cycles (whichever occurs first). In case of claim, please contact RED DIGITAL CINEMA at www.RED.com/support to obtain an RMA number. Instructions will be provided on how to return defective equipment to RED. Equipment found to be faulty in manu­ facture will be repaired or, at our option, replaced free of charge. This guarantee does not cover defects caused by incorrect handling, non-RED repair, un ...

has elapsed, immediately stop further recharging. Otherwise, electrolyte leakage, overheating, smoke emission, bursting and/or ignition may occur. • Do not put the battery into a microwave oven or a pressurised container. Rapid heating or punctured sealing may lead to electrolyte leakage, overheating, smoke emission, bursting and/or ignition. • If the battery leaks or gives off a bad odor, remove it from any exposed flame. Otherwise, the leaking electrolyte may catch fire, and the battery may emit smoke, burst or ignite. • If the battery gives off an ...

and/or ignition. • Do not use or leave the battery near a heat source such as a fire or a heater (> 80°C). If the resin separators should become damaged due to overheating, short- circuiting may occur inside the battery, possibly leading to chemical leakage, over­ heating, smoke emission, bursting and/or ignition of the battery. • Do not immerse the battery in fluids, water or seawater and do not allow it to get wet. Otherwise, the protective features inside the battery may be damaged and abnormal chemical reactions may occur, possibly leading to leakage, overheat­ ing ...

Battery can be connected to the RED ONE camera through the RED BATTERY PLATE, RED QUICKPLATE or RED CRADLE. CHARGING USING RED CHARGER 1. Plug AC power cord into charger AC input and power source. 2. Turn the charger power switch ON. 3. Insert battery into the V-plate adapter. 4. Observe the charger LED. Charger LED will illuminate Orange during charging (battery LED array will also illuminate displaying charge status). 5. Remove battery when charger LED flashes Orange/Green (all battery LEDs will be lit). NOTE: When a cable is plugged into the 6-pin LEMO auxiliary power output, the charging process will be sus ...

RED BRICK Discharge Voltage VS. Time at 60W and 80W Load State of Charge (%) Time (Min) ...

this OPERATION GUIDE, which is provided solely for the user’s information. While thought to be accurate, the information in this document is provided strictly “as is” and RED will not be held responsible for issues arising from typographical errors or user’s interpretation of the language used herein that is different from that intended by RED™. All safety and general information is subject to change as a result of changes in local, federal or other applicable laws. • RED reserves the right to revise this OPERATION GUIDE and make changes from time to time in the ...