Radionics D208RF Installation Instructions

Text of Radionics D208RF Installation Instructions

About This Document

To install the Expander: 1. Test the Expander at the desired location to evaluate performance in the particular envi- ronment. This document describes how to install, program, 2. Remove the Expander cover by pressing wire, and test the D208RF and D216RF Point down on the top center of the cover (see Fig Expanders. ure 2). I

Place the base on the

the provided screws. wall and secure it using CAUTION: When installing the Expander, only use screws that match the specifi- cations of the provided screws (Type AB, #6 x 1” tapping screws). TOP LATCHES flgure 3. Removing the Circuit Board J Figure 4. Mounting with Circuit Board Removed Connecting the Antennas to the Expander To co

CAUTION: You must be free of Static electricity

before handling circuit boards. Touch a bare metal surface or wear a grounding strap to discharge yourself. To program the Panel for the Expander: 1. 2. Select an address (7 or 8) by setting the address jumper to 7 or 8 (see Figure 8). Follow the programming procedure described in the Radionics docu

RF Point Expander Specifications

Compatibility: Radionics D2212 panel External Power: 7.5 - 14.0 VDC Class II Transformer Current Dmw: 50 mA maximum Operating Temperature Flange: 10” to 120°F Dlmenslons: 4-1/16” x 5-1/4” x 1” (Lx W x H) FCC Notice This device complies with FCC Rules Part 15. Oper- * ation is subject to the following two conditions

Radionics Control Unit Owners Instructions: