Climote HUB Installation Manual

mains before commencing installation Video Instructions Additional video instructions are available from climote on request ...

6 Functional Tests and Commissioning 7 – 8 Remote Access Test 9 Diagnostics 11 – 13 Thermostat Options 14 – 15 Customer Training 16 Safety Information 2 ...

Inside the Box Back-plate climote HUB Also included 1. Fixing screws. 2. Quick start guide. 3. Pocket guide. 4. Safety information. ...

Power up Unit 1. Switch on power to the unit. 2. Check scroll-wheel illuminates and unit enters start-up sequence – display shows “Unit initialising” for between 30 and 90 seconds. 3. Unit completes start-up and displays 3 timer dials . Note: in areas of poor signal quality, unit can take up to 5 minutes to complete its start-up seq ...

1. Navigate to Zone Setup Using the Menu/Back button and Scroll Wheel, select : 1. Menu. 4. Commission Device. 2. Settings. 5. Zone Setup. 3. Installer Settings. 2. Set up Zones 1. Active zones – On or Off. Set One, two or three zones to “On” to match the zone configuration. Turn scroll wheel to change, push to select, then ...

Log on with your installer Username and Password 1 . Log on to the climote Installer Site Navigate to https://climote.climote.ie/installer/login in any common browser1 1. All the climote website test functions can be carried out from a browser on any laptop, tablet or mobile device. The installer site also supports temporary insta ...

An administrator may already have pre-loaded your target device, in which case it will already be displayed. Select “View” to access If the device is not displayed, enter the Serial Number and Device Mobile Number and press “Add”. The device will be added to your device list climote Website Test (11) 1. 2. 3. 1 . Carry ...

Item Details 1 Start-up If start-up takes significantly longer than 90 seconds, it is usually a sign of a poor GSM signal or no coverage. The unit will finish its retries after 5 minutes and exit to the “Set Time” display. Set the time manually and complete manual checks, then follow “Poor Signal” actions below. 2 Time ...