Fire Com 3010R Series Installation & Operation Manual

3020R•3010R FIRE APPARATUS INTERCOM SYSTEM 3020R INTERCOM 3020R REMOTE HEAD ...

FIRECOM IS A DIVISION OF SONETICS CORPORATION 7340 SW Durham Road • Portland, Oregon 97224 U.S.A. • 800-527-0555 • 503-684-6647 • Fax: 503-620-2943 email: [email protected] • [email protected] • www.firecom.com © 2007. Sonetics Corporation. All rights reserved. The information in this document is subject to ch ...

1. 3010R SERIES INTERCOMS The Firecom 3010R Series Apparatus Intercom Systems, when used with Firecom noise- attenuating headsets, provide protection from hearing loss that can occur from exposure to high noise levels, while also providing each firefighter clear communication with the other crew members. Each crew member wi ...

2. SYSTEM OVERVIEW This section provides an overview of the 3010R Series Intercom System and an introduction to its individual components. Figure 2 shows a typical system. Refer to this diagram for each component. INTERCOM The main control unit for the 3010R Series Intercom System which contains all the controls and inter ...

3. 3010R SERIES FRONT PANEL Figure 3 shows the Front Panel of the 3010R and the 3020R Intercom. Listed below are the different items on the Front Panel and what they control/signify. These controls are explained further in “Intercom Operation” (pages 24, 25, & 26). VOLUME UP & VOLUME DOWN BUTTONS Adjust the master volum ...

4. 3010R SERIES REAR PANEL Figure 4 shows the Rear Panel of the 3020R Intercom. This section describes the different connectors located on the rear of the intercom. RADIO INTERFACE JACK(S) A 9-Pin D-Sub connector, which provides the attachment point for the Mobile Radio Interface Cable. The jack for radio B is only present ...

5. DEFINITIONS This section lists some of the more common terms used in this manual and gives their description. Familiarize yourself with these terms before proceeding with the installation of a 3010R Series Intercom. CA CABLE: Flat, six conductor cable, which may have RJ-12 Modular Plugs on each end, used to make connectio ...

6. Before installing the Firecom 3010R Series Intercom System, it is VERY IMPORTANT to take a little time and plan the installation. This section will provide information to assist in planning the installation. You should read AND UNDERSTAND all of the information contained in this section as well as the sections on the System ...

7. HEADSET MODULES There are 2 different types of Headset Modules for the 3010R Series Intercom system (Figure 5). The HM-10 is the standard module and is designed for use inside the apparatus where it is protected from the elements. The HM-10 also has a second connection for Daisy-Chaining (page 8). The second type of headset ...