Cytech UCM Series Manual 

19 System Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 USB Connector . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 LED Indicators on Daughter Board . . . . . . ...

37 Section 6 Firmware and Vocab Upgrading . . . . . . . . . . . . . 35 Problems with Learned IR Codes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35 Infrared Learning Errors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

The Universal Communications Modules allows Comfort to connect via RS232 interface, USB or Local Area network to a computer or external equipment. The types of UCM include; UCM/ETH02 The UCM/ETH02 has a RJ45 jack for connection to an Ethernet Local Area Network (LAN) using the TCP/IP protocol. The UCM/ETH02 is a new model which repla ...

Comfigurator Firmware Upgrade. 6 Comfort Voice/Vocabulary (new version of language) can be written to Comfort using Comfigurator. There are also application-specific UCMs which interface to specific third party systems for example, UCM/CBUS for Clipsal’s CBUS, UCM/KNX for the KNX Bus, ...

Getting Started This section is common to UCM/232, UCM/ETH02 and UCM/USB Connections Connect the UCM to Comfort using the supplied white cable with 4-way connector on both ends. It plugs into JP2 or JP2A on the UCM and “RS485” 4-pin header (J6) connector on Comfort II. This supplied cable can be used for short runs (about 30 ce ...

will be an addressing conflict which will prevent proper communication. ID Setting using COPY Switch (from UCM 6.080) From UCM Firmware 6.080, the UCM ID can be changed by use of the COPY switch. If SW7 A to D are all OFF, then the UCM ID is determined by the saved setting in the U2 EEPROM. P ...

the number of modules to Comfort. LED Indications Once the UCM is connected with the ID setting set correctly, the LEDs D10 (green) and D9 (red) will flash continuously, and the D1 RDY green LED should stay on. The RDY LED indicates that the power is on. D10 green led blinking indicates RS ...

Other Settings (SW8) Not Used Not Used H Not Used Not Used G UCM/ETH02 UCM/ETHf01 F Not Used Not Used A to E Off - Open On - Short SW8 Table 2-4 - SW8 Settings SW8-F shunt should be inserted for UCM/ETH01 and left out for UCM/ETH02 or if the UCM is not an Ethernet Module. SEE NOTE below SW8 - H ...

The UCM/ETH02 module allows the Comfort system to be connected to a Local Area Network. This module converts the serial data of the UCM to the industry-standard TCP/IP protocol over the Ethernet. This allows the Comfigurator software to read and write Comfort configuration and allows Wizcomfort which is a stand-alone user softw ...

The UCM/ETH02 is equivalent to a UCM06 Baseboard with ETH02 daughter board plugged in. ETH02 Specifications  Ethernet Interface: 10/100BaseT  Network Protocols: TCP, UDP, HTTP  Serial Interface baud rate: 9600 bits per second  Current Consumption: 80 mA (typical) from Comfort 12V auxiliary output. Ethernet Connecto ...