Heatit Z-PUSH BUTTON 2 Installer Manual

Text of Heatit Z-PUSH BUTTON 2 Installer Manual

PLEASE READ THIS BEFORE INSTALLATION

SAFETY & WARNINGS • This device contains a button lithium battery that shall be stored and disposed properly. • DO NOT expose the device to moisture. QUICK START • Step 1: Turn on your remote control. • Step 2: Activate inclusion mode on your Z-Wave controller. • Step 3: Activate inclusion mode of your

The remote control is a sleepy device, after adding it will

not enter into sleepy mode immediately, and will continue activation status for 30s and wait data interaction from the gateway, the LED indicator will stay solid on, please be patient to wait LED indicator to turn off. REMOVING FROM A Z-WAVE NETWORK There are two removing methods: Method 1: Removing

added maximum quantity associated devices that it supports ).

- LED blinks 5 times to indicate that the remote control added the associated device successfully. - LED blinks 8 times to indicate that the remote control removed the associated device successfully. TO REMOVE ALL ASSOCIATED DEVICES IN AN ASSOCIATION GROUP ON THE REMOTE CONTROL DIRECTLY: 1. Press

PRODUCT INFO Heatit Z-Push Button 2

• Battery operated wall switch with 2 push buttons • Fits Gira System 55, Elko RS-16 and Schneider Exxact frames • Controls 1 group and up to 5 units • Controls 4 scenarios via your gateway • LED-diode • Easy to install with screws and double-sided tape • Supports encryption mode: S0, S2 Authenticated Class,

VIKTIG: LES INSTALLASJONSVEILEDNINGEN FØR

INSTALLASJONEN SIKKERHET OG ADVARSLER • Denne enheten inneholder et litiumbatteri som skal lagres og kastes på forsvarlig vis. • NB! Enheten må ikke installeres i våtrom eller på steder der den kan utsettes for direkte fukt. HURTIGGUIDE Installasjon • Trinn 1: Skru på veggbryteren. • Trinn 2: Aktiver in

Selv om veggbryteren er en batteridrevet enhet, vil den i 30

sekunder etter inkludering fullføre aktiveringsprosessen. Den vil ikke kunne motta informasjon fra gatewayen. Mens den fullfører aktiveringsprosessen vil LED-indikatoren lyse. Vær tålmodig og vent til LED-indikatoren slutter å lyse. EKSKLUDERING (FJERN ENHETEN FRA Z-WAVE-NETTVERKET) Det er to

Heatit Control Unit Owners Instructions: