Montigo SP28-F2 Installation Operation & Maintenance

read all instructions prior to installation.
Leave this manual with the owner. Installation Operation & Maintenance
  
    
         
           ...

CAUTIONS Due to its high operating temperatures, the appliance should be located out of traffic & away from furniture and draperies. • Children and adults should be alerted to the hazards of the high surface temperature, which could cause burns or clothing ignition. • Young children should be carefully ...

XG0318 Figure 2. Framing dimensions.
     The fireplace may be installed in any location that is free of air conditioning ducts, electrical wiring and plumbing. Safety, as well as efficiency of operation, must be considered when selecting the fireplace location. Try to select a location that does ...

    The gas line must be installed before finishing the fireplace. Natural Gas requires a minimum inlet gas supply pressure of 5.5" W.C. & a manifold pressure of 3.5" W.C. Propane Gas requires a minimum inlet gas supply pressure of 11" W.C. & a manifold pressure of 10" W.C. Provision must also ...

XG0318     !     Combustible mantels and mouldings may be safely installed over the top and on the front of the fireplace provided that they do not project beyond shaded area shown in Figure 5. Side wall clearances are 0". Combusti- ble surrounds may be installed with 0" clearance to the side of ...

  
  % &  ' The burner tray may be installed/upgraded before or after the EP28 outer shell has been installed. 1. Remove the lower trims. 2. If you are converting or upgrading an EP28 Series fireplace which has doors installed, you must first remove the doors. To remove the door ...

XG0318
   Heat Circulating Blowers Some EP-28 Series decorative fireplaces may be equipped with an optional blower kit (Part # FAN28) for circulating heat into the living space. NOTE: If any of the original wire supplied with the appliance is replaced, it must be replaced with the same type, or its equivalent. ...

      % EP28 Series Decorative Models come standard with a firescreen, and may be fitted with one of the following optional door kits:
Twin-Pane-Style Doors ................ Part # ETW28
Bi-Fold Doors ....................... Part # EBD28
Stereo Cabinet Doors ................... Part # ETW ...

XG0318 9. Reconnect the primary limit switch as shown in figure 24c. Install the secondary spill switch in its location on the right side of the insert, centred in its location as shown in figure 20. Drop the wires beween the insert and the shell and connect the spill switch to the thermocouple-gas valve circuit as sh ...

Figure 22. Installing the hood and filler plates. Figure 23. Removing and installing the glass door.
   10. Reconnect gas line by following the information on page 4. 11. Turn on the gas supply and leak test the connection using a soap solution. 12. Install the new front bar as shown in figure 21. Fig ...