Acora Acoustics SRC-2 Owner's Manual

The SRC-2 has been designed to bring you closer to your music by using specialized drivers, custom hand-built crossover networks, and all granite enclosures constructed by artisans with decades of experience. Please read through this manual to ensure you get the years of musical truth from your new SRC-2s that we feel you should expect. The SRC-2 loudspeaker, as it is in a full granit ...

Each Acora Acoustics loudspeaker has been inspected and packaged with pride. Please verify that both crates are in good condition and the serial numbers are consecutive. We do not suggest unpacking the SRC-2 alone. Have your dealer or consultant perform or at least assist with this process. The SRC-2 is quite heavy and should not be moved without qualified assistance. 1) Remove the speaker from the crate per the instructions ...

amplifier should be switched OFF. Please double check all connections before turning the amplifier back on. Failing to do this could result in damage to your amplifier. The connection block on the SRC-1 will accommodate bare wire, spade lugs, or banana terminations. As you face the back of the speaker, the terminal on your left is the - NEG connector and t ...

While conditions vary widely, such as room size, preferred listening level, and content being listened to, these basic guidelines may be of value when mating the SRC-2s with the right amplification for you. Remember, it is easier to damage a speaker using an amplifier with less power than is needed to drive the speakers to the desired volume, than it is to damage the speakers with too much power. An amplifier being ...

​Woofer - 2 - 7” Sandwich Paper Cone ​Tweeter - 1” Soft Dome Ring Radiator Nominal impedance -4 ohm Suggested amplifier range - 10w - 250w Sensitivity - 92.5 1w/1m Frequency Range - 29Hz - 30KHz (+/- X dB) Enclosure - High Polish Black Granite 3cm Exterior dimensions - 14” x 18” x 43” Weight - 244lbs each ...

The SRC-2 granite enclosures require minimal care. We have included a small bottle of granite polish and a polishing chamois. These will restore the gloss and luster to your speakers’ enclosure, however it will damage your speakers’ drivers. Do NOT spray the polish on the drivers, do NOT use a damp cloth of any kind on the drivers themselves. Damage to the drivers due to moisture or polish would affect the sound quality, ...

165 Milner Ave Scarborough, ON, Canada M1S 4G7 (647) 812-3933 [email protected] Please, Enjoy! ...