AML Striker Quick Start Manual

side of this guide) LCD Front-Facing Speaker 1. 1. 2. 2. 3. 3. Open “Settings Turn ON WiFi Select network or ? to select hidden networks Getting Started Getting Started Getting Started Isometric Front Bottom View Top and Rear Views Striker Enterprise Mobile Computer Quick-Start Guide 800.648.4452 www.amltd.com 051420-1 1. 1. 2. 2. 3. 3. 4. 4. Slide the black tab down Pull battery door in the direction shown Remove/ replace battery Replace battery door and slide tab to locked position 1 Load the main battery 2 Charging your Striker 3 Setting Up Wi-Fi Connection ACC-7725 Charging Cradle 9001-M7700 revA Audio Jack Microphones Battery Door LED Flashlight Barcode Scanner Flashlight Trigger Scan Trigger 4. 4. Connect 12V DC, 2.5A Power supply AML Part#: PWR-8050, supplied with ACC-7725

AML reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult AML to determine whether any such changes have been made. The information in this publication does not represent a commitment on the part of AML. AML shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from the furnishing, performance, or use of this material. This document contains proprietary information which is protected by copyright. All rights are reserved. No part of this document may be photocopied, reproduced, or translated into another language without the prior written consent of AML. 2190 Regal Parkway Euless, TX 76040 800.648.4452 www.amltd.com www.barcodepower.com Safety NOM/NYCE-NOM-019-SCFI-1998 Safety of data processing equipment Regulatory Notice Accessories Register Your Product Getting Started Warranty Agreements SVC-EW7700 SVC-EWP7700 Extended Warranty, 3 year, M7700 Extended Warranty PLUS, 3 year, M7700 ACC-7725 Striker Single Slot Charging Cradle ACC-7735 4-Position Battery Charger CAS-7701H Holster with Belt ACC-7736 Striker Mobile Charging Cradle 1. Press and hold power button In order to help facilitate support inquiries please register your product. You can register your product(s) online at www.amltd.com/register www.amltd.com/register Laser Devices Class 2 laser scanners use a low power, visible light diode. As with any very bright light source, such as the sun, the user should avoid staring directly into the light beam. Momentary exposure to a Class 2 laser is not known to be harmful. The following statement is required to comply with US and international regulations. Label Reads COMPLIES WITH 21CFR1040.10 AND 1040.11 AVOID EXPOSURE. LASER RADIATION EMITTED FROM THIS APERTURE CAUTION LASER RADIATION DO NOT STARE INTO BEAM! 630-680nm LASER 1.0 MILLIWATT MAXIMUM OUTPUT CLASS II LASER PRODUCT LED Devices For LED devices which have been evaluated to IEC 62471 and comply with the Exempt Risk Group, no product labeling requirements apply. Howerver, the following statement is required to comply with US and international regulations: LED Compliance Statement: Classified as ‘EXEMPT RISK GROUP’ according to IEC 62471:2006 and EN 62471:2008. NO USER SERVICEABLE PARTS CAUTION Use of controls, adjustments, or the performance of procedures other than those specified herein may result in hazardous laser light exposure. Getting Started 2. Use the bar which appears on the Striker’s screen to power off Note: pressing the red power button without holding will activate Sleep Mode only. 4 Turning Off the Striker 5 Access Documentation 1. 1. Visit the website: www.amltd.com 2. 2. Click on Support in the Main Menu 3. 3. Click on Product Documentation 4. 4. Documentation below found under Striker • Wi-Fi Setup • Barcode App • Lockdown Utility • Clone Utility for USB and PC • Firmware Updates • Sideloading an Application