ALZRC 3GYS Instructions Manual

Text of the manual

Instructions for the ALZRC 3-axis gyro

1. Introduction ALZRC 3GYS is a small, light weight, high-performance 3-axis gyro, for various levels of electric and gas helicopters. It uses a High-performance processor, which can do very fast operations. Its main use is for the control of RC model helicopters, and can be used as a stand alone tail rotor control gyr

Supported swashplate types

4. LED indications Red light Working in tail lock gyro mode Blue light Working in the non tail lock gyro mode Red and blue light Gyro has not received any signal Red and blue lights flashing Initialization failed, please keep the gyro still and the rudder stick at center Red light keeps flashing Gyro in firmware upgrade mode 5. G

◆The gyro has three installation directions that can be chosen: 1, 2 & 3

Direction 1: Direction 2: Direction 3: 6. Servo arm and connecting rod installation 6.1 Swashplate servo ◆ Firstly, confirm that the rotor head and swashplate mechanical parts are installed correctly, and move smoothly, before being connected to the servos. ◆ The proposed positio

Note: After completion of the above rudder setup, do not connect the rudder servo to the gyro.

7. Remote Device Settings In the transmitter, create a new helicopter model without any mixing functions. Select 1 servo (90 degree) mode (Futaba: H1; JR: 1 servo NORM; Hitec Aurora 9: 1 servo (90°)). For all channels, set the fine-tuning value (Trim) and the int

Note the correct orientation of the data cable plug

The programmer will boot and display "ALZRC 3GYS Loading data!". After a successful connection the display will show "Load succeed!", and then displays the first menu "Basic setup". 9.2 Monitor Use the "Monitor" menu to check the transmitter settings are correct. When the screen shows "Basic setup", press t

A gyro mode switch should be setup in the transmitter to change between locked tail and non lock tail mode.

The following table is a list of major transmitter brands showing the suggested values that should be uses. After transmitter setup, set the switch to the tail locked mode position. After the "G:" an "A" should be displayed. Toggle the switch to the no

return to "Load model".

9.4 Rudder servo type selection When the screen shows "Load model", press the DOWN/DATA- key to display "Tail servo type", and then press enter to select it. There are five types of servos to choose from: ◆ "1520us 72Hz" all the servos are analog servos ◆ "1520us 250Hz" broadband digital rudder servo is a servo (Futaba S9253, S925

Adjust the swashplate servos "Servo 1", "Servo 2", "Servo 3" value, so that all the swashplate servo arms are

level and the rods are vertical. Then adjust the servo arm to the swashplate pushrods, so that the swashplate is level. Now adjust the blade arm pushrods for zero degrees pitch. Adjust the rudder servo "Servo 4" value, so that the rudder servo arm an

9.8 Servo position adjustment limit

When the screen shows "Servo reverse" press the DOWN/DATA- key to display "Servo limit", and then press ENTER to select it. Move the rudder stick to the full left and right position, and adjust the "Tail limit A" and "Tail limit B" so that the maximum travel is used without any binding at the limit. Press ENTER to change t

Other Remote Control Manuals