BASKETBALL PROBASE PROBASE Installation Manual

Text of the manual

- 2 -

IMPORTANT SAFETY NOTICE • ADULT SUPERVISION IS REQUIRED DURING THE ASSEMBLING AND THE INSTALLATION OF THE PROBASE. • MISUSE OF A SLEDGEHAMMER CAN RESULT IN SERIOUS INJURY. • ALWAYS WEAR SAFETY GOGGLES WHEN USING THE SLEDGEHAMMER. • ENSURE THAT THERE IS ENOUGH ROOM AROUND YOU SO THAT YOU CAN SWING THE HAMMER FREELY. • MAKE SURE PEOPLE ARE AT L

- 3 -

*For assemblies including flange nuts (intergrated washer nuts), you will not have flat washers in your kit. INSTALLATION GUIDE COMPONENTS A Stake (2 identical components) B Main pole holder C Pivot D Pivot base E Removable front cover F Pressure plate G Tapping block (plastic or wood) H Tapping block Holder I Handle bolts J Bolts K

- 4 -

*For assemblies including flange nuts (intergrated washer nuts), you will not have flat washers in your kit. INSTALLATION GUIDE EXPLODED VIEW F E J A K D C B I

- 5 -

*For assemblies including flange nuts (intergrated washer nuts), you will not have flat washers in your kit. INSTALLATION GUIDE TOOLS NEEDED A Crowbar or steel rod B Sledgehammer C Level D 17 mm Open key wrench or ratchet tool with an 17mm socket A B C D

- 6 -

INSTALLATION GUIDE *For assemblies including flange nuts (intergrated washer nuts), you will not have flat washers in your kit. 1 CHOOSE YOUR SPOT Choose a location that allows a stake to be pushed in and that is located directly behind a solid surface such as pavement or a concrete curb. 1.1 1.2 2 MAKE A PILO

- 7 -

INSTALLATION GUIDE *For assemblies including flange nuts (intergrated washer nuts), you will not have flat washers in your kit. 4 ASSEMBLE THE PIVOT BASE TO THE STAKE Assemble the pivot base (D) to the upper part of the stake, aligning the 4 holes of each part. Insert 4 bolts (J), 4 flat washers* (L) and 4 nuts (K) into the 4 holes, and tighten the bol

- 8 -

INSTALLATION GUIDE *For assemblies including flange nuts (intergrated washer nuts), you will not have flat washers in your kit. 6 PREPARING THE TAPPING BLOCK Place the tapping block (G) inside the pivot base (D). Insert the tapping block holder (H) into the grooves of the tapping block and push them between the bolts to the base of the tapping block.

- 9 -

INSTALLATION GUIDE *For assemblies including flange nuts (intergrated washer nuts), you will not have flat washers in your kit. 9 REMOVE TAPPING BLOCK, TAPPING BLOCK HOLDER AND HARDWARE Once the stake is firmly inserted into the ground, remove the tapping block (G), the tapping block holder (H) the 8 bolts (J), the 8 flat washers*, the 8 nuts and set a

Other Sports & Outdoors Manuals