Beyerdynamic MIX 10 NG Operating Instructions Manual

Line Inputs. - 5 RCA Input Channels,Mix,Tuner,Tape,CD and Aux Intputs. - Ultra-low noise discrete Mic Preamps with +27V Phantom Power. - Warm , natural 2-band EQ on each channels. - Peak LEDs - 2 Phoenix Outputs,Master and Subgroup Outputs. - 3 RCA Outputs, Master and Record and R ...

BLOCK DIAGRAM JUMP CH1 JUMP JUMP CH2~6 JUMP JUMP JUMP REC OUT REC OUT/ RETURN TUNER LINE AP 232 JUMP JUMP JUMP JUMP JUMP JUMP JUMP RIGHT LEFT MIX INPUT MASTER SUBGROUP LEVEL SUBGROUP OUTPUT SUBGROUP OUTPUT MASTER OUTP ...

CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN This symbol, wherever used, alerts you to the pre- sence of un-insulated and dangerous voltages with- in the product enclosure. These are voltages that may be sufficient to constitute the risk of electric shock or death. Protective Ground Terminal AC mains (Alternating Current) Hazardous Live ...

1.Version 2.Safety Information Thank you for selecting the MIX 10 NG 10-channel-stereo-mixing-system. Please take some time to read carefully through this manual before setting up the equipment. MIX 10 NG-23210-channel-stereo-mixing-system (115V).................Order#483.850 MIX 10 NG-23210-ch ...

(11) REMOTE - 9-pin Sub-D connection for remote control AP 232 for RS 232 interface (PCB), refer to chapter "9. AP 232 Retrofit Kit" (12) Ground Lift to separate operating ground from mains ground. The ground lift is activated when the switch is switched to the left. (13) Master Output, +6 dB, master o ...

Four separate RCA-line inputs (phono) are on the rear of the unit. One of these four line inputs can be selected with the source selection switch (3). The inputs are unbalanced and suitable for the connection of stereo devices. The input gain can be adjusted for each input on the printed circuit board (refer also to chapter "6. Configuration ...

(1)Mic 1~Mic 6 send signal to master L+R Bus (2)Mic 1~Mic 6 send signal to Sub L+R Bus (3)MIX INP send signal to Master L+R Bus (L: J25, R:J27) (4)MIX INP send signal to Sub L+R Bus (L: J26, R: J28) (5)Mic 1~Mic 6, MIX INP send signal to Master L+R Bus (L: J10, R: J16) (6)Line channel send signal to Master L+R Bus ...

An external source selection of the line inputs can be done via the 9-pin Sub-D remote connection (11) with the corresponding wiring. LEDs indicating the corresponding status feedback. For devices that are to be operated with RS 232 serial interface control (for example media control systems such as CUE, Crestron, A ...