BMC timemachine road Assembly Instructions Manual

...

Di2 Cable routing Headset & Fork installation Seat clamp and seat post installation Rear brake installation Brake pad configuration Front brake installation Notes 4 6 7 9 10 11 15 16 19 1 / 2 ...

performance. Integration being a key part of the system’s performance, it is necessary to understand that most components of the frameset have been designed specifically for timemachine TMR01 and their function may slight ...

1. Insert the rear derailleur cable housing from the right dropout, and then run it into the frame (1). Exit at the head tube opening on the left side (2). 2. Insert the front derailleur cable housing from the right side head tube opening (3). Run it through the down tube and exit at the bottom bracket on the lef ...

Note: For all matters regarding Di2 cable routing, please refer to the official Shimano instructions. This chapter only offers guidelines in order to properly place the Shimano wires into your TMR01 frame. 1. Use a shifting cable to guide the Di2 rear derailleur wire through the chain stays. Enter the frame at the drop out and exit at t ...

4. Mount the battery inside the seat tube, guide the wire from the battery towards the bottom bracket and exit there. 5. Connect all Di2 wires coming out of the bottom bracket to the junction, please refer to Shimano installation instructio ...

1. Note that the rear brake cable housing should be installed before installing the fork. 1. Apply grease on the bearings (N°3 and 4) and on the bearing seats of the frame. Place the bearings in the frame. 2. Apply grease on the fork shaft, and then slide the fork through the bearings and the head tube. 3. Slide the compression ...