Buffalo ABARL47 Installation Instructions

Text of Buffalo ABARL47 Installation Instructions

ITEM # ABARL47 / ABARL53 INSTALLATION INSTRUCTIONS

READ AND UNDERSTAND ALL WARNINGS BEFORE ASSEMBLY ITEM # ABARL47 / ABARL53 INSTALLATION INSTRUCTIONS READ AND UNDERSTAND ALL WARNINGS BEFORE ASSEMBLY PACKAGE CONTENTS: SPECIFICATIONS: NOT RECOMMENDED FOR USE WITH KAYAKS Objects that extend forward or behind your vehicle must be tied down front and rear to the

ITEM # ABARL47 / ABARL53 INSTALLATION INSTRUCTIONS

READ AND UNDERSTAND ALL WARNINGS BEFORE ASSEMBLY Remove roof bars and accessories when entering an automatic car wash. ROOF BAR SPACING THE ROOF BARS SHOULD BE NO LESS THAN 36 INCHES APART. USE FOLLOWING CALCULATION TO DETERMINE SUGGESTED SPACING: TAKE 30% OF OVERALL LENGTH OF ITEM BEING CARRIED. (EXAMPLE: I

Attach the support brace on the opposite mount

Measure distance between support braces 4 5 6 Note: the distance is measured between the outer edge of each support brace 7 Cut Channel Strip Insert to that length. (Channel Strip helps reduce wind noise) Insert key to unlock and remove End Cap Remove Channel Strip Insert from bottom of rack Attach the support b

Slide Channel Strip Insert into

the bottom of rack 8 Loosen screw and slide rack, short Channel Strip Insert at bottom, into support brace Slide rack into the support brace on the opposite side. (Trim Channel Strip again if rack doesn’t fit completely ) 9 ITEM # ABARL47 / ABARL53 INSTALLATION INSTRUCTIONS READ AND UNDERSTAND ALL WARNINGS BEFORE ASSEMBLY QU

Buffalo Automobile Accessories Owners Instructions: