bSeen Basic Edition Owner's Manual

INTRODUCTION INSTALLATION DIAGRAM BOX CONTENTS SYSTEM SPECIFICATIONS ECU CONTROL UNIT INSIDE LOOK OUTSIDE LOOK POWER SUPPLY CHARGING PORT CONNECTIONS HANDLEBAR SWITCH LED UNITS - OVERVIEW LED UNITS - CRIMP CONNECTORS LED UNITS - CABLE CRIMPING ECU CONNECTORS LED UNITS - CONNECTIONS TO ECU BSEEN FUNCTIONS HANDLEBAR SWITCH - BASIC FUNCTIONS H ...

bSeen is an indicator light kit developed for electric scooters, electric bicycles and any other vehicle that lacks of indicators, and light warning systems. Sold as a “do it yourself” kit, bSeen is a powerful and reliable system, based on the latest technologies. Inside bSeen there’s a powerful ...

Box 1 contents: 1 x ECU control unit 1 x Li-ion Battery charger Box 2 contents: 1 x Handlebar switch unit 1 x set of LED units (4 or 5 depending on your kit) 1 x 2 metres of 5mm width foam double tape 2 x spare crimp connectors SYSTEM SPECIFICATIONS ECU unit LED units Handlebar switch unit Battery Pack: ...

The ECU is the “brain” of bSeen’s system. Inside the ECU there’s a 12V Samsung battery pack with three 18650 batteries in series, with a total current output of 3000mAh (3A). To manage the charge and the discharge cycles, the battery pack is monitored by an electronic balance management circuit, which guarantees the bat ...

Outside the ECU control unit, you will find: 1 x Charging Port 1 x ON/OFF Switch 1 x Cable tail with a mini connector for the tail LED unit (bSeen standard version only) 2 x Cable tails with mini connectors for the REAR indicators (L&R) 2 x Cable tails with mini connectors for the FRONT indicators (L&R) 1 cable tail with a wa ...

ECU CONTROL UNIT - POWER SUPPLY Your bSeen kit is supplied with a PSU (Power Supply Unit) especially designed to charge 12V li-ion battery packs. On bSeen’s PSU there is a LED monitor, and at the end of the cable there is an aviation 2 PIN connector. USE ONLY BSEEN PSU TO CHARGE YOUR ECU The PSU’s electronic circuit detec ...

On the top of bSeen’s ECU there’s a waterproof protected connector. Opening the protection cap will reveal the 2 pin aviation male connector. Without plugging the PSU to the mains (110V-240V): • Switch the ECU OFF • Plug the 2 pin aviation connector from the PSU to the charging port on the ECU (please note that you need to align b ...

The handlebar switch unit it’s fitted with a 2 metres length control cable. At the end of the cable there’s a green 5 pin waterproof connector. This connector will plug directly onto the ECU’s handlebar switch connector: On each connector’s enclosure, there’s a printed arrow. Once both arrows are aligne ...