CDA EVPC91 Installation, Use And Maintenance Manual

Text of the manual

Using your extractor

7 Timer function 7 Clean air function 8 Care and maintenance 8 Removing the grease filter 9 Changing/fitting the charcoal filter(s) 10 Changing the light 11 - 17 Installation 11 Installation preparation - height 15 Mounting the extractor 16 Ducting and ventilatio

The CDA Group Ltd cannot be held responsible for injuries or losses

caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance or use in a commercial environment. This appliance is not designed to

and requirements of EU Directive 2014/30/EU (EMC).

IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2012/19/EU. At the end of its working life, the product must be taken to a special local authority waste collection centre or to a dealer providing appliance recycling services. Disposing of a household appliance sepa

• This extractor has been designed to be used in a room with a

volume of less than 36m3. • Steam cleaners must not be used when cleaning this appliance. • The performance of your extractor will vary depending on a number of factors. These include: type of extraction, length of ducting, room volume, ventilation available and cleanliness of the fi

Using your extractor

For best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for approximately 15 minutes after the end of cooking (you can use the timer function, detailed on page 7, for this). Control Panel (Fig. 1) A - On (speed 1) and off button B - Speed 2 button C - Speed 3 button D - Intensive

To activate the timer function

• Press and hold the desired speed button for approximately 5 seconds to activate a 15 minute timer for that speed. The selected speed’s indicator should flash. Hold the same button for approximately 5 seconds to cancel the timer. Please note that the intensive speed automatically switches off after approximately 6 minu

Care and maintenance

IMPORTANT: DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY. Cleaning You should use a non-abrasive cleaner. Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings. You can clean your extractor effectively by simply using a dilu

Please note: After 30 hours of use the light button will flash to signal

that the filters needs to be cleaned. With the extractor off, press and hold the lamp button until it stops flashing to reset after cleaning. To remove the grease filters, lift the catch on the handle on the grease filter. It will release at the handle side. Lower it towards you sligh

Other Ventilation Hood Manuals