CAMBRIONIX EtherSync Operation & User’s Manual

EtherSync User Guide document revision 1.01 ............................................................................ 3 ..................................................................................................... 4 ........................................................................................ 5 ......................... ...

EtherSync User Guide document revision 1.01 Firmware Access LED. Will illuminate when EtherSync firmware accesses the internal charger Hardware SD Card LED. Will illuminate when EtherSync has access to an SD card inserted into the slot. Gigabit Ethernet Ports Power Input SD Card Input Power LED. Will flash a heartbeat pattern when EtherSync is p ...

EtherSync User Guide document revision 1.01 Power Supply Input Voltage: 100-240V ̴AC Input Current: 1.8A Input Frequency: 50 ̴ 60 Hz Input Connector: C14 Output Voltage: 12V Output Current: 8A Output Power (Total): 96W Output Connector: 4 pin Mini-DIN EtherSync Input Voltage: 12V DC Input Current: 8A Input Connector: 4 pin Mini-Din Output V ...

EtherSync User Guide document revision 1.01 A 96W Power Supply (we recommend a FSP096-ANAH2). A C13 power cord with your desired plug type (e.g. a G type plug for the UK). A standard RJ45 to RJ45 Ethernet cable. EtherSync Connector Software downloadable from: https://hub.cambrionix.com/pages/ethersync 1) Push the 4 pin Mini-DIN from the power su ...

EtherSync User Guide document revision 1.01 4) The EtherSync is now switched on, the bottom red LED should be illuminated and pulsing a ‘heart beat’ pattern. EtherSync has many more uses than those described below. In fact it is capable of performing almost all processes that can be done with a direct USB connection. EtherSync comes with two ...

EtherSync User Guide document revision 1.01 Note The initial password is used for access to Webmin and LiveViewer. To change the password for Webmin go to Webmin Users and select the user for which you wish to change the password i.e admin. In this section the password can now be changed. If you which to leave the password blank, set the passwor ...

EtherSync User Guide document revision 1.01 Note Hostname is not case-sensitive and must be unique. We recommend using a ‘Friendly Name’ appended with the mac address minus the colons, such as CambrionixXXYYZZ. The host name will change after successful reboot, which is initiated at the bottom of the Systems>>Boot up and Shutdown section. No ...

EtherSync User Guide document revision 1.01 2) Click ‘Add’ and enter the correct location of the desired EtherSync. Other EtherSyncs specified can also be removed from this section by highlighting the desired EtherSync and clicking ‘Remove’. Note The TCP Port 17575 must be open to the remote subnet. 3) Ensure EtherSyncs are connected to ...

EtherSync User Guide document revision 1.01 6) To use the device on the client computer, right click on the device and select ‘Use’ or any of the ‘Auto-Use…’ options. Auto-Use Device - Automatically uses the device no matter what port it is connected to. Auto-Use Port - Automatically uses the port no matter what device is connected to ...