BYOC Analog Chorus Instructions Manual

Analog Chorus Kit Rev 1.0 Instructions Warranty: BYOC, LLC guarantees that your kit will be complete and that all parts and components will arrive as described, functioning and free of defect. Soldering, clipping, cutting, stripping, or using any of the components in any way voids this guarantee. BYOC, LLC guarantees that the instru ...

experiencing. That being said, we will do our best to help you as much as we can. Our philosophy at BYOC is that we will help you only as much as you are willing to help yourself. We have a wonderful and friendly DIY discussion forum with an entire section devoted to ...

INSTRUCTION INDEX Parts Checklist««««««««..............««.....page 4 - 5 Populating the Circuit Board««««...................page 6 - 16 Main PCB Assembly««.........................................page 17 - 19 Wiring.........................................................................page 20 - 23 Installing the IC ...

Resistors: 1 - 47R (yellow/purple/black/gold/brown) 1 - 470R (yellow/purple/black/black/brown) 1 - 2k7 (red/purple/black/brown/brown) 4 - 4k7 (yellow/purple/black/brown/brown) 14 - 10k (brown/black/black/red/brown) 1 - 22k (red/red/black/black/red/brown) [used only for bass mods] 4 - 33k (orange/orange/black/red ...

pot. 2 - B100k linear (depth & rate knobs) IC's: 1 - 4558 1 - 3102 1 - 3207 1 - TL022 4 - DIP 8 socket Transistors: 4 - 2N5088 Hardware: 1 - drilled enclosure w/ 4 screws 1 - byoc Analog Chorus PCB 1 - 3PDT footswitch 2 - knobs 1 - AC adaptor jack 1 - ¼´mono jack 1 - ¼� ...

layout on the PCB. The stripped end should go in the square solder pad. Note that the 1N4001 diode goes in the space highlighted in yellow. The two small orange 1N4148 diodes go in the space highlighted in red. ...

goes in which solder pad. Be careful of the 47ohm(labelled 47R on the PCB) and 470ohm (labelled 470R on the PCB) resistors. Don't confuse them with the 4k7, or 47k resistors. BASS MOD: The 33k resistors highlighted in green and yellow are the resistors you would want ...

up with the end that has a notch on the layout. Only add the socket. DO NOT solder the actual chip to the PCB. DO NOT solder the chip to the socket. Only the socket gets soldered. You will never solder the chips. Installing the chips or IC's into the socket will ...

so that the flat side of the component matches up with the flat side of the PCB layout. Be sure not to mix up the 2N5088's with the 2N5087. ...