Cardinal 2XX-IP Installation Manual

FOR 200 SERIES INDICATORS INSTALLATION MANUAL 8200-M503-O1 Rev A PO BOX 151 • WEBB CITY, MO 64870 Printed in USA 0604 PH (417) 673-4631 • FAX (417) 673-5001 http://www.cardinalscale.com ...

CAUTION! This device contains static sensitive circuit cards and components. Improper handling of these devices or printed circuit cards can result in damage to or destruction of the component or card. Such actual and/or consequential damage IS NOT covered under warranty and is the responsibility of the device owner. Electr ...

NOTE! Should your indicator come with the 2XX-IP board already installed, the following information describing the mounting of the board does not apply. Proceed to the Ethernet Cable Installation section. ATTENTION! OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC SENSITIVE DEVICES 1. Make sure ...

After all terminations have been made, remove the excess cable from the instrument enclosure and securely tighten each of the cable gland connectors. Do not over-tighten these connectors but make certain they are snug. DO NOT USE TOOLS! Finger-tighten only! Insure any unused gland connectors are plugged. ...

May 11, 2009 Cardinal Scale Manufacturing Co. P.O. Box 151 - 203 E. Daugherty Webb City, Missouri 64870 Phone: 417-673-4631 - Fax: 417-673-5001 http://www.cardinalscale.com ...

(red square key in center of the Navigation arrows). The display will change to show the SETUP/REVIEW MENU. SETUP/REVIEW MENU 1.ENTER CALIBRATION AND SETUP 2.VIEW AUDIT TRAIL COUNTERS 3.CALIBRATE SCALE 1 Enter Selection: 1 ^EXIT Press the ENTER key, then ...

1. CONT=XXX 2. TYPE=X XXXXX 3. SCALE=X Enter Selection: 0 ^EXIT 1. CONT=XXX To turn the continuous data output ON or OFF, press the 1 key and then the ENTER key. 2xx-IP SETUP MENU CONT=XXX YES NO Press the YES and ENTER keys to turn continuous data output ON, press the NO and ENTER keys to turn it of ...

2. TYPE=X To select the format of the data transmitted from the 2xx-IP card, press the 2 key and then the ENTER key. 2xx-IP CONTINOUS OUTPUT SELECTION 0. SMA 5. NUMERIC WT 1. SB400 6. SB500 2. SB200 7. SB250/500M 3. IQ355 4. TOLEDO SHORT TYPE=X Enter the 1-digit value for the desired format and press the ENTER k ...