Cognex DataMan 475 Quick Reference Manual

when you install the Cognex product: l The verifier is intended to be supplied by a UL or NRTL listed power supply with a 24VDC output rated for at least 2A continuous and a maximum short circuit current rating of less than 8A and a maximum power rating of less th ...

connector. Cable shielding can be degraded or cables can be damaged or wear out faster if a service loop or bend radius is tighter than 10X the cable diameter. l This device should be used in accordance with the instructions in this manual. l All specifications are for reference purposes ...

Accessory Power and I/O breakout cable, M12-12, straight, xx specifies length: 5 m, 10 m, 15 m, angled, xx specifies length: 5 m, 10 m, 15 m CCB-PWRIO-xx CCB-PWRIO-xxR X-Coded to A-Coded Ethernet cable adapter, 0.5 m CCB-M12X8MS-XCAC X-Coded to RJ45 Ethernet Cable (xx specifies length: 2, 5, 15, 30 m) CCB-84901-2001-xx I/O extension c ...

CAUTION: The Ethernet cable shield must be grounded at the far end. Whatever this cable is plugged into (usually a switch or router) should have a grounded Ethernet connector. A digital voltmeter should be used to validate the grounding. If the far end device is not grounded, a ground wire should be added in compliance wi ...

DataMan system; do not force the connectors or damage may occur. CAUTION: It is recommended the verifier be grounded, either by mounting the verifier to a fixture that is electrically grounded or by attaching a wire from the verifier’s mounting fixture to frame ground or Earth ground. I ...

CAUTION: The Ethernet cable shield must be grounded at the far end. Whatever this cable is plugged into (usually a switch or router) should have a grounded Ethernet connector. A digital voltmeter should be used to validate the grounding. If the far end device is not grounded, a ground wire should be added in compliance with local e ...

ENET connector. 2. Connect the Ethernet cable's RJ-45 connector to a switch/router or PC, as applicable. 9 ...

CAUTION: To reduce emissions, connect the far end of the Breakout cable shield to frame ground. Note: l I/O wiring or adjustments to I/O devices should be performed when the verifier is not receiving power. l You can clip unused wires short or use a tie made of non-conductive material to tie them back.Keep bare wires separated from ...