Code Blue InterAct 500 Series Administrator's Manual

IA500 Models 500-d, 500-s, 501-d, 501-s Administrator Guide Installation | Setup ...

GU-144-M page 2 of 24 IA500 Administrator Guide Table of Contents Section Page 2 Introduction...................................................................................3 3 Getting Started.............................................................. ...

GU-144-M page 3 of 24 IA500 Administrator Guide 2 Introduction Thank you for choosing the Code Blue InterAct 500 series analog speakerphone(s), intercom(s) and paging device(s) for indoor and outdoor applications. These speakerphones are part of our Emergency Si ...

GU-144-M page 4 of 24 IA500 Administrator Guide 3 Getting Started 1. The analog phone line will terminate on the barrier strip at Tip and Ring positions. a. Talk voltage: 24~48 b. Loop Current Range: 27~50mA 2. Relay: The phone has one relay that can be a st ...

GU-144-M page 5 of 24 IA500 Administrator Guide 4 Wiring Diagram IA500 SERIES PCB RELAY OUT RNG TIP Relay Output can be used to trigger an optional strobe as shown. Another application for this output would be a door control system. Refer to the IA500 programmin ...

GU-144-M page 6 of 24 IA500 Administrator Guide 5 Installation The IA500 Series comes in surface and fl ush mount options. The surface mount allows the mounting bracket to be installed during rough in and the faceplate with electronics during completion. The f ...

GU-144-M page 7 of 24 IA500 Administrator Guide 1. Remove the four faceplate screws from the back box 2. Using the back box as your guide on the wall, mark the rough opening size 3. Create the required opening and conduit runs 4. Pull CAT 3 cable through the cond ...

GU-144-M page 8 of 24 IA500 Administrator Guide 6 CB 5 Series Curb Mount Installation Instructions 1.0 PRE-INSTALLATION Electrical Preparation – The unit will need a phone wire (POTS) run through the curb mount with at least 10 inches of wire coming out of the ...

GU-144-M page 9 of 24 IA500 Administrator Guide Specifi cations subject to change without notice or obligation on the part of the manufacturer. ...

GU-144-M page 10 of 24 IA500 Administrator Guide 7 Programming The IA500 series can be programmed from any touch-tone telephone keypad or through the use of Code Blue’s Unit Programming & Diagnostics (UPD) software. There are basically two modes of operation: ...