Cisco 1120 Quick Start Manual

www.cisco.com Connecting the Router to Power This section describes how to connect the Cisco 1120 Connected Grid Router to AC and DC power source These topics are discussed:  Before You Begin, page 43  AC Power Connection Information, page 45  Connect to AC Power, page 49  Connect to DC Power, page 50  Power Cycling the ...

— Wiring compatible with the power supply used at your site: single-phase or three-phase, rated 10A minimum — Plug that is compatible with the power source used at your site: single-phase or three-phase. — Correct length for your installation  DC power cable that meets the following requir ...

 AC power can be readily and conveniently removed from the router. The power should not be removed by disconnecting the AC power connector on the unit. Warning: The plug-socket combination must be accessible at all times, because it serves as the main disconnecting device. Statement 1019 Warning: ...

Figure 1 on page 46 shows the label for each terminal. Electrical Wire Color Codes This section provides general information about the standard wire coloring used for AC and DC power connections. Use these colors as a guide when wiring the terminal block as part of the AC power and DC power connection procedure ...

The router ships with two connectors used to connect power to the AC and DC power connectors on the router.  The AC power connection mating connector is a 5-way screw terminal printed circuit board plug connector manufactured by Phoenix Contact (part number 1913604). Figure 2 on page 48 shows ...

. Figure 3 DC Power Connector Item Description Quantity 1 Captive screws, for connecting terminal block to mating connector on the router 2 2 Terminal openings for inserting AC-input source wires 5 3 Screws for tightening wires into terminal openings 5 Item Description Quantity 1 Terminal openings for inserting DC-input source ...

Connect to AC Power This section describes how to make two the following types of AC power connections to the router:  Single-phase AC  Three-phase AC Note: The AC power connection mating connector shipped with the router is a 5-way screw terminal printed circuit board plug connec ...

4. After the wires are inserted into the connector terminals, use the screwdriver to tighten the connector screw terminals. The screw terminals are shown in Figure 2 on page 48. 5. Connect the AC power connector to the AC power connection on the router as shown in Figure 4 on page 49. 6. Use the screwdriver to tighten th ...

appropriate length for the DC power connector, about 0.25 inches. 3. Insert the wires into the DC power connector terminals described in Figure 1 on page 46 and Table 1 on page 46. Note: When you insert the wires in the terminals as shown in Fi ...

Item Button Description 1 CONFIG Reset Press the CONFIG Reset button for at least 5 seconds to return the router software configuration to the factory default, and power cycle the router. Power cycling the router turns the router off, then immediately back on. The router will temporarily stop operating on the networ ...