Dell PowerEdge 1750 Ser's Manual

 Using the System Setup Program  Technical Specifications  Using Console Redirection  Glossary Abbreviations and Acronyms  For the full name of an abbreviation or acronym used in this document, see the "Glossary." Information in this doc ...

Technical Specifications Dell™ PowerEdge™ 1750 Systems User's Guide   Technical Specifications Technical Specifications Microprocessor Microprocessor type up to two Intel® Xeon™ microprocessors with a minimum internal operating frequency of at least 2.0 GHz Front-side bus speed 133 MHz  Address bus speed 266 MHz (doub ...

Video Video type ATI Rage XL PCI video controller; VGA connector Video memory 8 MB Power Power supply:  Wattage 320 W (AC)  Voltage 100–240 VAC, 50/60 Hz, 3.9–2.0 A  Heat dissipation 1026 BTU/hr maximum per power supply  Maximum inrush current Under typical line conditions and over the entire system ambient operating range, the ...

Using Console Redirection Dell™ PowerEdge™ 1750 Systems User's Guide   Hardware Requirements   Software Requirements   Configuring the Host System   Configuring the Client System   Managing the Host System Remotely   Configuring Special Key Functions  Console redirection allows you to manage a host (local) system f ...

l  Set Data bits to 8. l  Set Parity to None. l  Set Stop bits to 1. l  Set Flow control to Hardware. 5.  Click OK. Configuring the Terminal Settings 1.  In HyperTerminal, click File, click Properties, and then click the Settings tab. 2.  Ensure that the Function, arrow, and Ctrl ...

to the host system. The host system then interprets the sequence as .  Additional escape sequences may be required by certain utilities or functions on the host system. Create macros for th ...

System Overview Dell™ PowerEdge™ 1750 Systems User's Guide   Indicators on the Optional Bezel   Front-Panel Features and Indicators   Back-Panel Features and Indicators   System Features   Supported Operating Systems   Power Protection Devices   Other Documents You May Need   Obtaining Technical Assistance  You ...

and Connectors SCSI Hard-Drive Indicator Codes Indicator, Button, or Connector Icon Description blue system status indicator The blue system status indicator lights up during normal system operation. Both the systems management software and the identification buttons located on the front and back of the system ...

hard drives. See Figure 1-3 and Table 1-3. The SCSI backplane firmware controls the drive power-on/fault indicator. Figure 1-3. SCSI Hard-Drive Indicators  Table 1-3 lists the drive indicato ...

 When connecting external devices to your system, follow these guidelines: l  Most devices must be connected to a specific connector and device drivers must be installed before the device operates properly. (Device drivers are normally included with your operating system software or with the device itself.) See the documentation ...