Digisol DG-GR1321 Quick Installation Manual

Text of the manual

Copyright 2018 by DIGISOL SYSTEMS LTD. All rights reserved.

Company has an on-going policy of upgrading its products and it may be possible that information in this document is not up-to-date. Please check with your local distributors for the latest information. No part of this document can be copied or reproduced in any form without written consent from th

1:1 Product Description

Overview Figure 1 Thank you for choosing DG-GR1321 ONU. The terminal devices are designed for fulfilling FTTH and triple play service demand of fixed network operators or cable operators. The device is based on mature GPON and Gigabit EPON technology, which has high ratio of performance to price, and the technology of 802.11n WiFi (2

1:3 Technical Parameters

Technical item DG-GR1321 PON interface 1 GPON/EPON connector, SC single-mode/single-fiber, GPON: uplink 1.25Gbps, downlink 2.5Gbps; EPON: symmetric 1.25Gbps Wavelength Tx:1310nm, Rx:1490nm Optical interface SC connector LAN interface 1* 10/100/1000Mbps and 1*10/100Mbps auto adaptive Ethernet interfaces (RJ45). 1* POTS (RJ11). Wirele

1:5 Panel Description

Figure 3 Name Function PON Connect GPON or EPON port with internet by SC type, single mode optical fiber cable. FXS 1 Connect the telephone with FXS port by telephone wire. LAN1 / LAN2 Connect PC to device Ethernet port by RJ-45 cable. Pair (Wireless Pair) Press down Wi-Fi pair button for WPS function. WiFi Press down Wi-Fi button to e

1:6 Indication Panel

Figure 4 Name Status Description Power OFF Power is not supplied ON Power is supplied PON OFF Device is not registered to OLT ON Device has been registered to OLT FLASH Device registered incorrect LOS OFF Received optical power is normal FLASH Received optical power is lower than the sensitivity of the optical receiver LAN1/LAN2 OFF Dev

1. Connecting the optical fiber cable to the unit.

a) Remove the protective cap of the optical fiber. b) Clean the end of the optical fiber with an optical fiber end cleaner. c) Remove the protective cap of the ONU optical interface (PON interface). Connect the fiber to the PON port of the unit. Note: When measuring the optical power before connecting to

2:2 Set Up Connection

Set Up Wired Connection Connect PC with ONU Ethernet port by RJ-45 cable. The PC will receive the IP automatically from the ONU DHCP server in the range of 192.168.1.x/24. Then access the ONU using IP address 192.168.1.1 with username/ password: admin Set Up Wireless Connection Choose the wireless network name (SSID)

Other Wireless Router Manuals