ELEKTRA Selftec Installation Manual
Text of ELEKTRA Selftec Installation Manual
ELEKTRA SelfTec® heating cables are intended for
the antifrost protection of:
• pipeline systems up to 50 mm in diameter,
• sprinkler systems,
• drain pipes for condensate outlets in air condi-
tioning and ventilation systems,
• actuators,
as well as for the protection against snow and ice of:
• gutters,
• downpipes,
• roof drains.
Characteristics
ELEKTRA SelfTec® self-regulating heating cables
increase their heating power when
Construction of the ELEKTRA SelfTec® heating cable
Technical properties
ELEKTRA SelfTec® self-regulating heating cables
are terminated at one end with a 3 metre-long
power supply conductor with a hermetic plug,
and a connecting joint at the other.
Technical parameters:
• specific heat output (at +10°C)
16 W/m
• power supply voltage
230V/~50/60 Hz
• external dimensions of the cable
~6x8 mm
• min. installation temperature
-25
• ELEKTRA SelfTec® heating cable
• “cold tail” power supply conductor
• connecting joint between the power supply conduc-
tor and the heating cable
• label
• end joint
• hermetic plug
1
2
3
4
5
6
5
Pipeline systems, sprinkler systems, etc.
Length of the heating cables depends from:
• pipe’s diameter,
• min. ambient temperature on the installation site.
Value 1 signifies parallel positioning of the cable
along the pipe. Values higher than 1 signify the
length of the heating cable per 1 m of heated
pipe. In this case, the cable should be spiralled
along the pipe.
Table 1. Length of the heating cable per 1 m of the heat
Heated pipeline systems, sprinkler systems,
etc., must be insulated.
!
Gutters, downpipes
Selection of the adequate length of the heating
cables depends from:
• min. ambient temperature in the area of the
installation site.
* if the building is located in the regions of intense
snowfall
The values are given for gutters of diameters
Ø100-125 mm.
Min. ambient
temperature
Number of segments
of the heating cable
[°C]
Above -5°C
Below -5°C
gutters