EINHELL RT-PL 82 Original Operating Instructions

Hand-Held Electric Planer Anleitung_RT_PL_82_SPK7:_ 08.04.2010 8:04 Uhr Seite 1 ...

...

...

Wear ear-muffs. The impact of noise can cause damage to hearing.  Wear a breathing mask. Dust which is injurious to health can be generated when working on wood and other materials. Never use the device to work on any materials containing asbestos!  Wear safety goggles. Sparks generated during working or splinters, chips and dust emitted by the device can cause loss of sight.  Anleitung_RT_PL_82_SPK7:_ 08.04.2010 8:04 Uhr Seite 6 ...

must be observed to avoid injuries and damage. Please read the complete operating manual with due care. Keep this manual in a safe place, so that the information is available at all times. If you give the equipment to any other person, give them these operating instructions as well. We accept no liability for damage or accidents which arise due to non-observance of these instructions and the safety information. 1. Safety information Please refer to the booklet included in delivery for the safety instructions.  CAUTION! Read all safety regulations and instructions. Any errors made in foll ...

 Wear protective gloves. 5. Before starting the equipment Before you connect the equipment to the mains supply make sure that the data on the rating plate are identical to the mains data. Always pull the power plug before making adjustments to the equipment.  Important: For safety reasons, the electric plane must not be operated with the storage compartment for accessories (9) inserted. 5.1 Adjusting the chip depth (Fig. 4/Item 1) You can adjust the chip depth in steps of 0.1 mm from 0 to 3 mm by turning the setting knob for the chip depth (1). Turn the setting knob for the chip depth (1) in a cl ...

 There are three V-shaped grooves (a) in the front base plate that enable you to plane edges at an angle of 45° for a smooth finish. You can choose from three different sizes of V-shaped grooves (a).  Switch on the tool and wait until it reaches full speed. Place the required V-shaped groove (a) on the edge of the workpiece at an angle of 45°.  Now move the electric plane along the edge of the workpiece.  To achieve a good quality result you should keep the feed speed and angle constant. 6.2.3 Planing steps (Fig. 9/13)  The planing of steps is possible with the help of the parallel stop (13).  Mount the ...

in reverse order. Check that the planing knife conforms with both ends of the planing shaft. Always replace both knives to ensure a uniform chip depth. Important: Before using the hand-held electric plane make sure the knives are installed securely and in the right place. Check the correct setting (Fig. 16) (8) Front base plate (moving plane shoe) (5) Rear base plate (fixed plane shoe) 1. Correct adjustment Result: Smooth planed surfaces 2. Notches in the surface Problem: The cutting edge on the planing knife (or both planing knives) is not parallel to the height of the rear base plate. 3. ...

of documentation and papers accompanying products is permitted only with the express consent of ISC GmbH.  Technical changes subject to change Anleitung_RT_PL_82_SPK7:_ 08.04.2010 8:04 Uhr Seite 11 ...

Dear Customer, All of our products undergo strict quality checks to ensure that they reach you in perfect condition. In the unlikely event that your device develops a fault, please contact our service department at the address shown on this guarantee card. Of course, if you would prefer to call us then we are also happy to offer our assistance under the service number printed below. Please note the following terms under which guarantee claims can be made: 1. These guarantee terms cover additional guarantee rights and do not affect your statutory warranty rights. We do not charge you for this guarantee. 2. Our guarantee only cove ...