DRAGONFIRE 11-0800 Installation Instructions

Chandler, AZ 85225 1 (800) 708-9803 WWW.DRAGONFIRERACING.COM DragonFire Universal LED Chase Light Part # 11-0800 27” LED Chase Light Black Housing Part # 11-0801 36” LED Chase Light Black Housing Congratulations on your purchase of the DragonFire Universal LED Chase Light! Make sure to check additional DragonFire products for your UTV at your local Authorized DragonFire Dealer or online at http://www.DragonFireRacing.com . • Read and understand these instructions before installing product • Check Local Law/Requirements before use • Never drive under the influence Disclaimer Off road activities can be hazardous and could lead to injury, dismemberment, paralysis and death. No warranty of representation is made as to the products ability to protect the user from any injury or death. The user assumes that risk. The acceptance and /or use of this merchandise purchased from DragonFire by the customer hereby shall release DragonFire from any and all liability pertaining to the use of such merchandise.

and remove keys from the ignition. Step 2: Locate the desired chase light mounting point on your vehicle. We recommend that the Chase Light be installed on the rear of the vehicle, either on the Roll Cage, or the back of the roof, facing the back, and high enough to be seen. Mount the chase light with the Logo facing up, using the 2 screws on the back of the chase light, or the supplied brackets. As Shown on Figure A. We recommend using our Universal Clamps (Part Number # 11-0036) for increased versatility (Sold Separately). As Shown on Figure B. Step 3: Locate the tail light cables, and test each one of them using a multi- meter to determine the brake light. You will need to turn the ignition key to auxiliary in order for the tail lights to turn on. The multi-meter/ Test- Light should not display power until pressing down the brake pedal. Step 4: Once the power wire is identified, tap into the brake light cable using a connector (Not Included), or solder the yellow wire with a green stripe from the chase light to the brake light cable. View Figure C. The Blue (Right Turn) and Brown (Left Turn) wires are optional turn signal wires. View Figure D for reference. Our turn signal kit is sold separately. Part & Hardware List Item QTY Description Step Used P1 1 Chase Light with Cables Step 2 P2 1 Push Button Cycle Switch Step 6 P3 1 Rocker Switch Step 5 P4 2 Battery Terminals Step 5 P5 4 4mm x .7 Screws Step 2 P6 2 Mounting Brackets Step 2 Tools Required Phillips Screw Driver Digital Multi-Meter/ Test-Light Socket Wrench Razor Knife .56” Drill Bit (9/16”) Mounting Bolts

switch on your dashboard. Recommended hole size for the Rocker Switch is 1.43” x .850”.The rocker switch powers the Chase Light. Connect the Battery Terminal Cables to the battery. Figure E shows how the rocker switch should be connected. Step 6: Run the Push Button Cycle Switch wire harness to the dashboard. Drill a hole on your dashboard with a .56” Drill Bit, and install the Push Button Cycle Switch on your dashboard. The Push Button changes the Flashing Amber Light pattern. There are a total of 7 patterns to choose from. Figure G shows the Push button Cycle Switch. Note: Chase Light Diagram displayed in Figure F. For further assistance please contact us at [email protected], or by phone at 1-800-708-9803.