Digi TX64 Operation & User’s Manual

B February 2020 Release of DigiTX64 firmware version 20.2: n Digi SureLinkTM support (formerly known as active recovery). l Enabled by default on preconfigured WANs and WWANs. n Role-based user access. l Allow shell option added to authen ...

n Support for LDAP user authentication. n Preconfigured Wi-Fi SSID and password enabled by default. l The default SSID for both of the access points is: Digi-TX64-serial_number l Default password is the unique password as found on the device's label. You will need to change t ...

commitment on the part of Digi International. Digi provides this document “as is,” without warranty of any kind, expressed or implied, including, but not limited to, the implied warranties of fitness or merchantability for a particular purpose. Digi may ...

Digi TX64 Quick start Quick start using the Digi Remote Manager mobile app 15 Step 1: What's in the box 15 Step 2: Gather accessories 16 Step 3: Connect 17 Step 4: Power up 18 Step 5: Configure 18 Digi TX64 hardware reference TX64 key features 19 TX64 hardware specifications 19 TX64 ...

6 TX64 power connector 27 Configuration and management Review TX64 default settings 29 Local WebUI 29 Digi Remote Manager 29 Default interface configuration 29 Other default configuration settings 31 Reset default password for the default admin user 32 Reset default SSIDs and pre-shared keys for the preconfigured Wi-Fi access points 33 Config ...

7 Show serial status and statistics 174 Wi-Fi Wi-Fi configuration 177 Default access point SSID and password 177 Default Wi-Fi configuration 177 Configure the Wi-Fi module channel 179 Configure the Wi-Fi module band and protocol 181 Configure a Wi-Fi access point with no security 183 Configure a Wi-Fi access point with personal security 189 C ...

8 Show the routing table 301 Dynamic DNS 303 Configure dynamic DNS 303 Virtual Router Redundancy Protocol (VRRP) 309 Configure VRRP 309 Show VRRP status and statistics 313 Virtual Private Networks (VPN) IPsec 315 IPsec data protection 315 IPsec modes 315 Internet Key Exchange (IKE) settings 315 Authentication 316 Configure an IPsec tunnel 316 ...

9 Configure the system time 473 Network Time Protocol 476 Configure the device as an NTP server 476 Configure a multicast route 482 Enable service discovery (mDNS) 485 Use the iPerf service 488 Example performance test using Iperf3 493 Applications Configure applications to run automatically 496 Task one: Upload the application 496 Task two: ...

10 Disable shell access 582 Set the idle timeout for TX64 users 583 Example user configuration 586 Example 1: Administrator user with local authentication 586 Example 2: RADIUS, TACACS+, and local authentication for one user 588 Firewall Firewall configuration 596 Create a custom firewall zone 596 Configure the firewall zone for a network int ...