Extech Instruments 407227 Operation & User’s Manual
Text of Extech Instruments 407227 Operation & User’s Manual
2 407227_407228-en-GB_v3.2 10/18
Introduction
Thank you for selecting the Extech Model 407227 pH, mV, and Temperature Meter. This
device measures pH, mV (ORP), and Temperature. The temperature units (C/F) are
selectable and the Calibration and Slope adjustments are conveniently located on the
front panel.
The 407228 is the kit that includes the 407227 meter, pH electrode, temperature probe,
protective holster jacket with stand, and carr
3 407227_407228-en-GB_v3.2 10/18
Meter Description
1. BNC connector for pH or optional ORP probe
2. RS-232 PC interface jack
3. LCD display
4. pH electrode
5. Calibration and slope adjustment potentiometers
6. Temperature probe jack
7. LCD contrast adjustment
8. Keypad:
POWER: Press to turn the meter ON or OFF
HOLD: Press to freeze/unfreeze the displayed reading
C/F: Press to select the desired unit of measure for temperature
RECORD: Pr
4 407227_407228-en-GB_v3.2 10/18
Temperature Compensation
For accurate pH measurements and calibration, the temperature of the solution under
test must be known. This can be accomplished manually or automatically. Refer to the
steps for each, below, and determine the best method for the application.
Automatic Temperature Compensation
For Automatic compensation, use the supplied thermometer.
Perform these steps before each use or when th
Extech Instruments 407227 5 407227_407228-en-GB_v3.2 10/18
pH Operation
Important note: Manual or Automatic Temperature compensation must be engaged
before proceeding with pH calibration and pH measurements.
pH CALIBRATION
Note: It is recommended that the meter be calibrated at least once per day.
1. Connect the pH electrode to the meter’s BNC input jack and rinse it with distilled
water.
2. Press the POWER key to turn the meter ON.
3. Place the electrode in a
Extech Instruments 407227 6 407227_407228-en-GB_v3.2 10/18
ORP Operation (mV)
1. Connect the optional (67500B) mV ORP electrode to the BNC input jack at the top of
the meter.
2. Turn the meter ON using the POWER button.
3. Select ‘mV’ (millivolts) via the meter’s front panel slide-switch.
4. Rinse the ORP probe in distilled water.
5. Place the electrode in the test solution and read the millivolt (ORP) value.
6. Rinse the electrode with distilled water bef
7 407227_407228-en-GB_v3.2 10/18
Battery Replacement
The low battery indicator (LBT) appears when the 9V battery needs replacing.
1. Remove the meter's protective jacket.
2. Open the battery compartment using a coin or screwdriver.
3. Replace the 9V battery and re-assemble.
Never dispose of used batteries or rechargeable batteries in household
waste.
Users are legally required to take used batteries to appropriate collection
sites, the
8 407227_407228-en-GB_v3.2 10/18
Specifications
General Specifications
Display
Dual function LCD with contrast adjust
Input impedance
1012 ohms
Temp. compensation for pH
Automatic and manual 0 ~ 65°C (32 ~ 149°F)
pH electrode compatibility
Any pH electrode with BNC connector
Data hold
Freezes displayed reading
Memory recall
Records / Recalls MAX (maximum), MIN
(minimum), and AVG (average) readings
Auto Power OFF
Meter powers OFF after