Framery O Maintenance Instructions Manual

2 Tools and accessories................................................................................ 7 3 General inspection...................................................................................... 8 4 Check sound ins ...

11.4 Install the wall cover panels............................................................................... 42 11.5 Install the roof cover panels............................................................................... 42 11 ...

disassembly of the pod. It is important that these instructions are followed to recognize and prevent potential risks before they occur. Note: All personnel must understand and observe these instructions prior to installation, maintenance or disassembly of th ...

• Ambient temperature: +15°C ... +30°C (59°F ... 86°F) • Humidity: max. 50% 6 Framery O VCR Maintenance instructions [email protected] ...

Figure 1: Tools and accessories needed for installation and maintenance Note: Use a white rubber mallet to prevent marks on the body covers. Note: Use a plastic chisel to remove the body covers. Note: Use a lint-free cloth to clean the pod. Note: Use a mild alcohol-based cleaning solution to clean the pod. Framery O VCR Maintenanc ...

Check: • that the floor is level. • the straightness of the pod. • the pod for wear and tear. • the pod for visual defects. • that the door is in the middle of the opening and not sagging. • that the seal is in good condition. Poor condition of the seal can affect the pod's sound insulation. • that the handle is not too loo ...

1. Go into the pod and close the door. 2. Listen to the incoming sounds or check the seal seam. Tip: Typical leakage point is the handle side top corner. 3. Use a flashlight to locate the part of the seam where the light shines through. Framery O VCR Maintenance instructions [email protected] 9 ...

5.1 Disconnect the power cord To provide a safe working environment, disconnect the power cord. 5.2 Remove the body covers To access the frame bolts, remove the body covers. 1. Remove the wall body covers. 10 Framery O VCR Maintenance instructions [email protected] ...