Graco 127650 Instructions Manual

333469E FOR DIESEL EXHAUST FLUID (DEF) (ISO 22241) EN • FR • ES NOT APPROVED FOR USE IN EXPLOSIVE ATMOSPHERES OR HAZARDOUS LOCATIONS MODEL 127650 MAX WPR 345 kPa (3.4 bar) (50 psi) Important Safety Instructions Read all warnings and instructions in this manual. Save these instructions ...

3 B1 WARNINGS 4 C BECOMING ACQUAINTED WITH THE DEF DISPENSING NOZZLE WITH METER 5 C1 INTENDED USE 5 D TECHNICAL DATA 6 E INSTALLATION 6 F MODES OF OPERATION 7 F1 MECHANICAL CHARACTERISTICS 7 F2 ELECTRONIC CHARACTERISTICS 7 F3 PREVENTION MISFILLING (optional) 8 G PRELIMINARY CHECK 9 H INITIAL START UP 10 ...

Important precautions To ensure operator safety and to protect the pump from potential damage, workers must be fully acquainted with this instruction manual before performing any operation. Symbols used in the manual The following symbols will be used throughout the manual to highlight safety information and precautions o ...

exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manual or on warn- ing labels, refer back to these Warnings. Product-specific ha ...

tive gloves during dispensing Personal Protective Equipment Wear appropriate protec- tive equipment when in the work area to help pre- vent serious injury, includ- ing eye injury, hearing loss, inhalation of toxic fumes, and burns. This equipment includ ...

Part number Min. fl w-rate Max. fl w-rate Pressure loss at 35 l/ min (9.3 gpm) Inlet thread with swivel External diameter hose-end fittin Max. operating pressure Weight 127650 15 l/min 45 l/min 0.9 bar 1” GAS 20 mm 3.5 bar 0.8 Kg 4 gpm 12 gpm 13 psi 1” BSP .787 in 50 psi 1.8 lb NOTE The wetted materials used in this device a ...

F1 MECHANICAL CHARACTERISTICS FOREWORD The main feature of these nozzles is that they are easy to use. Two operating modes are available: 1 ASSISTED MODE Dispense by operating the nozzle lever. To interrupt dis- pensing manually, release the lever. 2 AUTOMATIC MODE Use the opening lever lock device for automatic dispens- ...

PREMISE Refuelling with the nozzle equipped with “magnet switch” is only possible in combination with the “magnet adapter” , so misfuelling into tanks is made impossible OPERATION The “magnet switch” is a fi ed magnetic field within the filler necks of the nozzle. This opens the magnet switch in the ...

NOTICE Check the correct operation of the lock device, ac- cording to the following procedure: 1 Take a graduated receptacle with a capacity of 20 litres (5 gal) LOW CLIP 2 Begin dispensing into the receptacle, setting the lever in the minimum fl w position, until the receptacle is full. 5 cm 3 Keeping the lever open, m ...

FOREWORD Only start dispensing after making sure that assembly and installation have been correctly performed. WARNING TOXIC FLUID OR FUMES HAZARD The faulty operation of this device could cause the spill of liquids that are hazardous for people and the envi- ronment. NOTICE It is a good practice to only operate the nozzle lev ...