Gecko in.k300 Tech Book

1 Warnings .........................................................................................................................................................................  2 Introduction ......................................................................................................................................................... ...

FAILURE TO COMPLY WITH THE FOLLOWING WARNINGS MAY SIGNIFICANTLY SHORTEN THE PRODUCT’S LIFE TIME, AND LEAD TO FAILURES AS WELL AS HAZARDOUS CONDITIONS*. COMMON SENSE MUST ALWAYS PREVAIL WHEN EVALUATING THE INSTALLATION AND/OR USE OF ANY ELECTRONIC CONTROL IN A FINAL APPLICATIO ...

The in.k300 brings all the features you really need to one keypad. Compact, with a big LCD screen; bright enough to be seen in day, simple enough to use in the middle of the night; affordable, yet solidly built. Item in.k300 Static LCD size (as measured diagonally) 1.5" Optional mounting with wing-nuts and spacers Double ...

To install the in.k300, use the drilling template provided in this section. Determine the mounting location and stick the template on chosen location. Cut out an opening according to the template. Clean the installation surface and peel the adhesive gasket from the back of the keypad. Insert keyp ...

the in.k300 on the outside edge of the hot tub, so that it is not subject to moisture trapped by the cover. The back of the in.k300 should not be enclosed where water can gather, but instead cut out. Keypad placement Connecting in.k300 keypad to the spa pack Vent hole on back of keypad should not be blocked. Installation notes ...

To start or stop an accessory, press the associated button. Indicators will light up when the associated accessory is on. When an accessory has more than two states, press the button until it reaches the desired state. Indicators will flash when dual speed pumps are on at low speed, and will be solid at high speed. If you have a b ...

Light key for 5 seconds. In the program menu the following parameters can be set: clock, filter or purge cycles, economy mode and temperature units. While in the program menu, use the Up or Down key to adjust the parameters and use the Light key to jump to the next parameter. The changes will ...

The display will show FSxx, “xx” representing the starting hour of the cycle. Use the arrow keys to adjust the hours. Use the Light key to jump to the next parameter, filter duration (Fd). Setting filter or purge cycle frequency The display will show FFxx, “xx” representing the number of cycles per day. Use ...