Furinno 11259 Manual 

FOLLOW THEM STEP BY STEP. CAUTION: 1. ADULT SUPERVISION IS REQUIRED DUE TO SMALL PARTS. CARE SHOULD BE TAKEN IN THE UNPACKING AND ASSEMBLY OF THE PRODUCT. 2. ASSEMBLE ON SOFT SURFACES TO PREVENT DAMAGE TO THE PRODUCT FINISH. 3. MAKE SURE ALL PARTS ARE INCLUDED BEFORE ASSEMBLY. Date: 16.10.2 ...

STEP 2 FIX SWITCH LOCK (5) INTO THE CAM LOCK OF EVERY PANELS, BEFORE ASSEMBLY THE UNIT. Date: 16.10.2014 ...

TURN ON CAM LOCK AND FIX INTO THE PRE-DRILL NUT. TURN OFF CAM LOCK WHEN THE PANEL WERE FIXED. Date: 16.10.2014 ...

REPEAT THE SAME METHOD AS STEP 3. STEP 5 UPRIGHT THE UNIT. ATTACH PANEL (A) TO IT. REPEAT THE SAME METHOD AS STEP 3. turn off lock Date: 16.10.2014 ...

INSERT PLASTIC PIN & NUT (3) AND PLASTIC STOPPER (2) INTO THE PRE-HOLES OF PANEL (M). Date: 16.10.2014 ...

REPEAT THE SAME METHOD AS STEP 3. STEP 9 FIX THE HANDLE SET (4) TO THE PANEL (H). STEP 8 SLOT IN PANEL (L) TO PANEL (I)(J), AS SHOWN. ATTACH PANEL (H) TO THE ASSEMBLED SECTION. REPEAT THE SAME METHOD AS STEP 3. Date: 16.10.2014 ...

USING WALL MOUNTING SET (6), ATTACH THE L-BRACKET TO THE TOP OF THE DRAWER CHEST WITH SHORT SCREW. DRILL A HOLE SMALLER THAN THE ANCHOR PLUG, INSERT THE ANCHOR PLUG INTO THE HOLE USING A RUBBER MALLET UNTIL THE ANCHOR PLUG IS FLUSH WITH THE WALL, THEN FASTEN IT WI ...