Honeywell FocusPRO TH6110D Manual 

heating and cool- ing systems, or 750 mV heating systems. System Types • (-?as,oil, or electric heat with air conditioning • Warm air, hot water, high-efficiency fl_rnaces, heat pumps, steam, gravi- ty • Heat only -- two-wire systems, power to open and close zone val ...

5 Power options ................................ 7 Thermostat moundng .................... 7 Appendices Quick refer ...

includes the following items: FocusPRO TM TH6110D programmable thermostat (wallplate attached to back) Quick reference card Wail anchors and AA alkaline mounting screws batteries (2) (2 each) Operating manual Required tools & supplies • No. 2 Phillips screwdriver • Small pocket sc ...

remove wallplate from thermostat. Remove the wallplate @ore the ther- mostat as shown at left, then fk>llow directions below for mounting. 1 ]insert quick reference card in slot in back of thermostat. 2 Pull wires through wire hole. 3 Position wallplate on wall, level and ma ...

shock or equipment damage. Disconnect power before wiring. Terminal block \ Wiring 1 Loosen screw terminals, insert wires into terminal block, then re-tighten screws. 2 Push excess wire back into the wall opening. Keep wires in shaded area as shown at left. Plug the wall opening with no ...

protection as required. ,_ Factory-installed jumper. Remove for 2-transformer systems only. _, Optional 24VAC common connection. in Installer Setup, set system type to Heat Only. ,_ in Installer Setup, set system type to Heat Pump & changeover valve to 0 or B ...

protection as required. A Factory-installed jumper. Remove for 2-transformer systems only. Optional 24VAC common connection. ,_, In Installer Setup, set system type to Heat Only. ,_ In Installer Setup, set system type to Heat Pump & changeover valve to O or B. Typical heat-only sy ...

"o - or _ _ o . ! Connect common side of transformer to "C" terminal Jumper Install batteries in back of thermostat (optional if AC powered). AC Power The thermostat can be powered by 24 VACpower, or by batteries. To wire the thermostat {k)rAC power, connect the coilln-lon side of the cooling tmnsfbrmer to the "C" t ...

below to configure the thermostat to match the installed heating/cooling system, and customize feature operation as desired. Function Setting number To begin, press and hold the A and FAN buttons until the display changes Press A or T to change settings Press N_T to advance to next function Press DONEto exit and save ...