IBM System X Series Rack Installation Instructions

Review the documentation that comes with your rack cabinet for safety and cabling information. When installing your server in a rack cabinet, consider the following:
Two or more people are required to install the device in a rack cabinet.
You must have a NetBAY25, NetBAY42, NetBAY42 Enterprise, NetBAY22 with Rack ...

locate the holes on the front and rear rack mounting flanges. Cage nuts Clip nuts 2 Cage nuts Install cage nuts or clip nuts as required for your rack cabinet. Use the cage-nut-insertion tool or a flat-blade screwdriver to install cage nuts. 3 Right slide rail Rear mounting flanges Left slide rail ...

fingers around the rack-support wheels
1 when positioning the server on the rails. Ensure that the handles
2 are fully upright as shown in the illustration above; then, use the handles to position the server in front of and level with the rails, aligning the channels on the sides of the server with the rai ...

cabinet; then, loosen but do not remove the four front M6 screws
1. While one person supports the front of the server by lifting it slightly, ensure that the front slide-rail brackets are vertically aligned; then, fully tighten the four front M6 screws. 10 Slide the server fully into the rack cabinet until it lock ...

13 Route the cables through the cable-management arm, securing them with cable straps
1. Use two cable straps
2 (one on each side of the hinge) to secure the power cords to the hinge plate. See the documentation that comes with your server and optional devices for complete cabling inst ...

IBM, NetBAY, and Netfinity are trademarks of the IBM Corporation in the United States, other countries, or both.  Copyright 2002 International Business Machines Corporation. All rights reserved. Note to U.S. Government Users — Documentation related to restricted rights — Use, duplication or disclosure is subject to restri ...