IBM SiteProtector SP3001 Mount Manual

Use the procedures in this section to install the appliance in a rack. The rails are for a 19 in. (48.26 cm) rack. The appliance ships with a slide rail kit and a shipping bracket kit. The contents of the slide rail kit are required to install the appliance. You can use the shipping bracket kit if you plan to transport the ...

a. From the front of the rack, line up the three pins on the rear of the slide rail with the three holes in the selected U on the rear of the rack. b. Push the rails so that the pins go into the holes
1, and latch down into place
2 until it latches into place. Note: 1) If you are installin ...

a. Install a 10-32 screw in the rear of the right slide. b. Install a 10-32 screw in the rear of the left side. Rack Front Figure 3. Install the front end of the slide rails Rack Rear Figure 4. Securing the appliance on slide rails in the rack Installing the appliance in a rack 3 ...

CAUTION: The weight of this part or unit is between 18 and 32 kg (39.7 and 70.5 lb.). It takes two persons to safely lift this part or unit. (C009) > 18 kg (39.7 lb) To install the appliance on the slide rails, complete the following steps as shown in Figure 5. 1. Pull the slide rail forward
1. 2. Use two people ...

disclosure restricted by GSA ADP Schedule Contract with IBM Corp. (P) PN: 46N5773 (2P) EC: L68311 *2PL68311* (4L) Origin: SG Printed in Singapore *4LSG* *P46N5773* Figure 6. Slide the appliance into the rack Installing the appliance in a rack ...