Husqvarna T425 Workshop Manual

Workshop Manual Husqvarna T425 List of contents Index ...................................................................... 4 Introduction and safety regulations ................... 6 Technical data ..................................................... 10 Service tools ....................................................... 12 Service data . ...

Index Index C Carburettor 35 Adjusting the carburettor 44 Assembly 40 Cleaning and checking 39 Design 35 Dismantling 37 Function 36 Pressure testing of carburettor 41 Centrifugal clutch 32 Assembly of centrifugal clutch 33 Cleaning and checking 33 Dismantling the centrifugal clutch 32 Chain brake 17 Assembling the chain brake 18 Cle ...

Index T Tank unit 45 Dismantling 45 Technical data 10 Throttle lockout, throttle and spring 23 Cleaning and checking 21 Cleaning and checking 24 Dismantling the throttle lockout, throttle and spring 23 Trouble shooting 54 Trouble shooting techniques 55 V Vibration damping system 46 Assembly 46 Cleaning and checking 46 Dismantling 46 ...

Introduction and safety regulations 2 Introduction and safety regulations List of contents 2.1 General information ........................................................................................................7 2.2 Safety ........................................................................................................ ...

2 Introduction and safety regulations Introduction and safety regulations 2.1 General information This Workshop Manual provides a comprehensive description of how to trouble shoot, repair and test the chain saw. A description of different safety measures that should be taken during repair work is also given. 2.2 Safety Note! The section dealin ...

2.8 General instructions The workshop where the chain saw is to be re- paired must be equipped with safety equipment in accordance with local regulations. No one may repair the chain saw without having read and understood the contents of this workshop manual. This workshop manual contains the following boxes in relevant places. 2.9 Special inst ...

Introduction and safety regulations 2.10 Symbols on the saw The symbols below are embedded in the chain saw. Choke control Refuelling Stop button Filling up saw chain oil 2.11 Symbols in the workshop manual This symbol warns of personal injury when the instructions are not followed. ...

Displacement Cylinder diameter Length of stroke Max. output/speed cm3/cubic inch Ømm/Øinch mm/inches kW/hp/ rpm T425: 25.4 / 1.55 34 / 1.34 28 / 1.10 0.96 / 1.29 / 9,000 Electrode gap Ignition system Air gap Carburettor type mm/inches mm/inches T425: 0.65/0.03 Ikeda Denso 0.3/0.012 Walbro WT 804 Usable cutting length Chain speed at Chain pit ...