Huawei Quidway Eudemon 200 Quick Start Manual

Note: Power cables may vary by country. Camera 200 (1) Power adapter (1) USB 3.0 cable (1) HDMI cable (1) Quick Start Guide (1) Remote control (1) AAA batteries (2) Mounting bracket (1) 1/4"-20UNC screw (1) Expansion bolts (4) M6 × 30 Philips screws (4) Certificate of Compliance & Safety Precautions &Warranty Card (1) ht ...

2 Status indicator Steady green: normal operation Blinking green: remote control is in use Steady orange: sleep mode Blinking orange: camera upgrade Blinking red: 1. Fault detected 2. Upgrading Single Chip Micyoco 3 Infrared receiver Receives infrared signals, supports NEC protocol 4 Power button Powe ...

Installation The Camera 200 can be placed horizontally, mounted on top of a display (such as TV set or monitor), wall-mounted, ceiling-mounted, or placed on a tripod. If the display is thicker than 170 mm or wall-mounted, the Camera 200 cannot be installed on top of the display. If the display is 17 ...

(4), M6 × 30 Philips screws (4). Not included: hammer drill (1), electric screwdriver (1), hammer (1), and Phillips screwdriver (1). First, drill four holes in the wall for mounting the bracket, each with a diameter of 8 mm (0.31 in.) and depth of 35–40 mm ...

Installation Procedure. The camera can be mounted both on top and on bottom of the bracket as shown below. Ceiling- Mounted Requires: Not included: ceiling bracket (1), 1/4"-20UNC screw (recommended) Bracket Requirements: ...

Matched Box Series Endpoints Example: The Camera 200 is connected to HUAWEI Box 500 directly through an HDMI cable or an HDMI cable adapter. HDMI connection: Weight bearing minimum of 8.5 kg (18.74 lb) and a thickness between 2 mm (0.08 in.) to 3 mm (0.12 in.) A location pillar which can be inserted into the location hole of the Ca ...

ports are available, connect the HDMI video input port of the Box 500 to the camera's HDMI port, and the Box 500's COM1 to the camera's RS232-IN port. Suggestion: Reserve a plugged-in USB cable for seamless PC upgrades in the future. HDMI adapter connection: Use an HD-VI adapte ...

Directly connect the Camera 200 to a PC with a USB cable after it is turned on. Start the Huawei CloudLink Meeting PC client. Go to the menu and go to Settings > Media > Video Device and select HUAWEI Camera 200. Sleep Mode: Use the IR remote control to set the sleep mode. Press MENU, go to Main Menu > Settings > USB Aut ...

Faulty detected Blinking green: remote control is in use Controlling the Camera The camera can be controlled from the connected HD video conferencing endpoint or IR remote control. When the HD video conferencing endpoint is used for camera control, the video cable and RS232 cable connection must be configured. ...

Use the Menu button to hide or display the On-Screen Display (OSD) configuration screen. There you can set the image output format, image parameters, and image inversion mode. IR Remote Control "+" refers to button combination sequence. Buttons Description Standby ...