HRS DF63 Series Manual 

It contains general guidelines and precautions for the safe use of the product. The use of the product in a way not as specified in the document could result in unexpected troubles such as damage to connectors. Please make sure to thoroughly read and understand the document prior ...

ETAD-H0892-00 0 2 /6 FORM HC0011-9-2 △ 3. Operation procedure 3-1. Insertion 3-1-a. Positioning for insertion: ：Adjust the position for insertion according to the locks of the socket or In-line plug. 3-1-b. Insertion: Insert the socket till it clicks while retaining the adjusted position. Then, it is not needed to handle the l ...

ETAD-H0892-00 0 3 /6 FORM HC0011-9-2 △ To avoid degraded quality, do not tilt the socket for insertion as shown in the figure below. 3-1-c. Check fitting: Make sure the socket has been firmly fit with the header or In-line plug. (Check that the socket lock has been caught at the header lock or In-line plug lock by slightly pull ...

ETAD-H0892-00 0 4 /6 FORM HC0011-9-2 △ 3-2. Socket removal 3-2-a. Removal: ：Remove the socket while pressing with a finger the lock spring on the socket to unlock. To avoid degraded quality, do not tilt the socket for removal as shown in the figure below. Fig.5 Socket removal Direction of removal Lock spring Fig6. Forbidden remo ...

ETAD-H0892-00 0 5 /6 FORM HC0011-9-2 △ Attention）Not to remove socket in the locked status as it will lead to breakage of locking portion or cable broken. If remove socket in the locked status, the lock is engaged to header lock portion as below picture shown. Then, it can not handle the lock. In this case, please insert the soc ...

ETAD-H0892-00 0 6 /6 FORM HC0011-9-2 △ 4. Precautions ・Do not insert or remove the socket while electrifying. ・Excessive external force applied to connectors could cause fault or damage. Therefore, avoid forced insertion or removal, impacts given by falling, or forced pulling of cables. ・Avoid insert socket by bundling the c ...