Jeep TTJL-01 Quick Start Manual
Text of the manual
JL TRAIL TABLE
(TTJL-01)
1. Begin my measuring out the holes on the rear door for drilling.
2. All holes will be drilled to 13/16” diameter bit. It is highly recommended to measure
hole placement on the vehicle and drill the holes with the plastic panel off the vehicle
to prevent damage.
3. Use below image for measuring. All measurements are from a fixed p
4. Once drilled, assemble gate table bracing as shown. Last bolt on bottom right will be
inserted once table is mounted.
5. Once the table is assembled as shown above, mount the table onto the door using the
provided (4) long bolts and the provided aluminum spacers. (NOTE: Long skinny
spacers will be used on the bottom, and shorter thicker spacers on top hol
6. Secure table ties onto surround here. Mount to the outside of the surround.
7. Mount lower half of table with provided hardware and spacers as shown.
If you have any question please email us at [email protected] or call us at
951-680-9595.