Kargo Master 4081M Installation Manual
Text of the manual
Rancho Cordova, CA 95742
800-343-7486
[email protected]
20210224R2
DATE: ______________
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST)
Page 1
Instructions – 4081M
*PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING,
INSTALLING, AND USING THIS PRODUCT.*
Warning
Always check for wires, fuel tanks and lines, brake lines, and other important
vehicle functionality items prior to drilling and installing all produ
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST)
Page 2
Instructions – 4081M
Parts
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST)
Page 3
Instructions – 4081M
Hardware
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST)
Page 4
Instructions – 4081M
Step 1 – Front Foot
Locate front mount locations as shown above.
Remove front most plastic cap in these locations to expose threads in the roof.
Place front rail pad over the front most hole. Place small foot (D) on top of pad.
Mount small
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST)
Page 5
Instructions – 4081M
Step 2 – Rear Foot Mount
In the rear of the van, locate the two rear most mounting locations from picture on
page 4.
Remove plastic to expose both threads in the roof.
Place small angle bracket (C) with flange to the center of van. Offset brack
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST)
Page 6
Instructions – 4081M
Step 3 – Rear Foot to Mount
The distance between the front and rear foot should be approximately 71.5”.
Place the correct large foot (A or B) on top of the angle bracket. The drivers side is shown
below. The slope on the large foot will make the
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST)
Page 7
Instructions – 4081M
Step 4 – Installing Ladder Bows
Place correct ladder bow on the previously mounted front and rear feet. Be sure to have
equal distance along the bow as shown below.
Bolt in place using 3/8” x 3/4” hex head, a 3/8” lock washer and a 3/8” fla