HK Instruments DPT-Flow-4 Series Installation Instructions Manual

www.hkinstrumentsinc.com Installation version 2.0 2017 INSTALLATION INSTRUCTIONS AIR FLOW AND VELOCITY TRANSMITTERS DPT-FLOW SERIES-4 • READ THESE INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO INSTALL, OPERATE OR SERVICE THIS DEVICE. • Failure to observe safety information and comply with instructions can result in PERSO ...

www.hkinstrumentsinc.com Installation version 2.0 2017 SCHEMATICS DIMENSIONAL DRAWINGS Figure 1a - Surface mounting Figure 1b - Mounting orientation Terminal Block Pressure Sensor LED Joystick 1 Zero V OUT P OUT 24V GND 4-20mA Out 0-10V Menu Buttons Joystick 2 Flow Joystick 3 Select Up Down Pressure Output Jumpers 3.54 (90 ...

www.hkinstrumentsinc.com Installation version 2.0 2017 OUTPUT SIGNAL CONFIGURATION CONTINUED STEP 4: CONFIGURATION MENU Figure 3 - Jumpers Terminal Block Pressure Sensor LED Joystick 1 Zero V OUT P OUT 24V GND 4-20mA Out 0-10V Menu Buttons Joystick 2 Flow Joystick 3 Select Up Down Pressure Output Jumpers Flow Pressure 4� ...

www.hkinstrumentsinc.com Installation version 2.0 2017 Continuing from the selection of Rectangle (inch) or Rectangle (mm). 1) Highlight submenu, the top line of the display will show WIDTH and the bottom line will change to a blinking number. 2) Cycle up or down by tilting joystick 2 or 3 respectively, to increase or dec ...

www.hkinstrumentsinc.com Installation version 2.0 2017 Continuing from the step 4-4, 4-7, or 4-19. The gain feature is designed to allow modification to the reported output, to match test and balance measurements, if necessary. The number shown is a multiplier. Increase the reported output by increasing the gain number abo ...

www.hkinstrumentsinc.com Installation version 2.0 2017 1) Highlight submenu, the top line of the display will show V OUTPUT MAX and the bottom line will change to a blinking number equal to the maximum output. 2) Cycle up or cycle down by tilting the joystick 2 or 3 respectively to increase or decrease the value shown on t ...

www.hkinstrumentsinc.com Installation version 2.0 2017 1) Highlight submenu, the display will change to FLOW UNIT and m/s will be blinking. 2) Cycle up or cycle down to select the correct flow unit. 3) Confirm selection when the correct option is shown on the display. 4) Cycle down to the next step in configuring the devic ...

www.hkinstrumentsinc.com Installation version 2.0 2017 HK Instruments, Inc. (HK) (a) WARRANTY COVERAGE: HK warrants to the original end user of the Products that the Products will, at the date of initial purchase, meet the applicable specification for such Products (as described by HK in its product literature) and, under ...