Grandstream Networks UCM6 series Configuring

Configuring UCM6XXX with GXW410X Table of Contents OVERVIEW ..................................................................................................................... 4 CONNECT UCM6XXX TO GXW410X USING PEER SIP TRUNK ................................. 5 Create IVR On UCM6XXX ............................................................. ...

Configuring UCM6XXX with GXW410X Table of Figures Figure 1: Create IVR 7002 on the UCM6XXX............................................................................................... 5 Figure 2: Create Peer SIP Trunk on the UCM6XXX ..................................................................................... 6 Figure 3: Configure Outb ...

Configuring UCM6XXX with GXW410X OVERVIEW This document describes basic configuration to interconnect UCM6XXX series and GXW410X. In this document, we are using GXW4104 as an example. The following methodology can be used for the GXW4108 as well. This is typically applied to the scenario where users would like to add a GXW410X not only as a remo ...

Configuring UCM6XXX with GXW410X CONNECT UCM6XXX TO GXW410X USING PEER SIP TRUNK Create IVR On UCM6XXX On the UCM6XXX web GUI, create an IVR extension under Call Features->IVR. In IVR settings, if "Dial Other Extensions" is enabled, the calls dialing into the UCM6XXX IVR will be able to reach the internal extensions registered to the UCM6XXX. Al ...

Configuring UCM6XXX with GXW410X Create Peer SIP TRUNK On UCM6XXX On the UCM6XXX web GUI, create a peer SIP trunk under Extension/Trunk ->VOIP Trunks. In this example, the GXW410X IP address is 192.168.5.159. Figure 2: Create Peer SIP Trunk on the UCM6XXX Configure Outbound Rule On UCM6XXX On the UCM6XXX web GUI, go to Extension/Trunk ->Outbound ...

Configuring UCM6XXX with GXW410X Figure 3: Configure Outbound Rule on the UCM6XXX In this example pattern "91XXXXXXXXXX", 9 is the first dialing digit and it will be stripped off when the call goes out. Configure Inbound Rule On UCM6XXX On the UCM6XXX web GUI, go to Extension/Trunk ->Inbound Rules to create a new inbound rule. In this example, w ...

Configuring UCM6XXX with GXW410X Figure 4: Configure Inbound Rule on UCM6XXX The default destination is configured to IVR. Ensure to select the proper extension for the IVR. Configure FXO Port On GXW410X When Peered with UCM6XXX 1. Connect the PSTN line to the GXW410X FXO port. 2. On the GXW410X web GUI, go to the Accounts->Account X-> General S ...

Configuring UCM6XXX with GXW410X Figure 6: Configure FXO Port on the GXW410X - SIP Settings Since we are going to use IVR when the call is forwarded to the UCM6XXX, UCM6XXX will need to be able to detect the DTMF digits. Configure the GXW410X FXO port DTMF settings as below for the initial setup. This can be found under Settings-> Channel Settin ...

Configuring UCM6XXX with GXW410X If the PSTN disconnects using the tones method, then turn on "Enable PSTN Disconnect Tone Detection" and turn off the "Enable Current Disconnect" option. Figure 10: Configure FXO Port on the GXW410X: Call Progress Tones For PSTN tone detection, the tone disconnect method is widely used everywhere else in the wor ...