Fujitsu M1010 Manual
Text of Fujitsu M1010 Manual
Copyright© 2008 Phoenix Technologies, Ltd., All
rights reserved.
Other product names are trademarks or registered
trademarks of their respective companies.
© Copyright 2008 Fujitsu. All rights reserved.
No part of this publication may be copied,
reproduced or translated, without the prior written
consent of Fujitsu. No part of this publication may
be stored or transmitted in any electronic form
without the written consent of Fujitsu.
This dev
9. If an extension cord is used with this product,
make sure that the total ampere rating of the
equipment plugged into the extension cord
does not exceed the extension cord ampere
rating. Also, make sure that the total rating of
all products plugged into the wall outlet does
not exceed 15 amperes.
10. Never push objects of any kind into this
product through cabinet slots as they may
touch dangerous voltage points that could
result in a fire or electric
13. CAUTION: When replacing the battery,
be sure to install it with the polarities in
the correct position. There is a danger of
explosion if the battery is replaced with
an incorrect type or is mistreated. Do
not recharge, disassemble or dispose
of in fire. Replace only with the same
or equivalent type recommeded by
the manufacturer. Dispose of the used
battery according to the manufacturer’s
instructions.
14. Power cable which is approved
The Load Number assigned to each telephone
terminal device denotes the percentage of the
total load to be connected to a telephone loop
or circuit which is used by the device to prevent
overloading. The termination on a loop may
consist of any combination of devices such that
the total of the load numbers of all devices does
not exceed 100.
For safety, users should ensure that the
electrical ground of the power utility, the
telephone lines and the meta
NOTE ON BACKUP DATA
Please make a backup of the Operating System,
any software programs, and created files (and
update regularly).
If you send this product to Fujitsu, or any of its
affiliates, suppliers, service providers or resellers
for repair, Fujitsu does not guarantee the data
integrity. It is your responsibility to back data up
beforehand.
Fujitsu does not assume any obligation for
compensation for damages, data integrity, or
restoration
• During installation and before operating
the device, observe the instructions on
environmental conditions in the manuals of
the device.
• Do not drop the device and protect it from
severe shocks.
• For mobile devices (e.g. notebook, pocket
PC, keyboard):
– Do not place any objects on the device.
– When the device is switched on, do not
store it in an environment with poor air
circulation
(e.g. in a carrier bag or a closed briefcase).
Otherwi
• For devices with a battery: improper
replacement of the device’s battery will result
in a danger of explosion. The battery may
only be replaced by an identical sort or by a
sort recommended by the manufacturer (see
device instructions).
• Do not use damaged cables (damaged
insulation, bare wires). A damaged cable
presents a danger of electrical shock or fire.
• If necessary, replace the original power cable
with a regular grounde