Fujikura FSR-02 Basic Operation Manual

Page 1 of 4 Fujikura FSR-02 Recoater Basic Operation Manual 1. PURPOSE The purpose of this instruction manual is to provide basic instructions on the common functions of the FSR-02 recoater. The FSR-02 is used to recoat and proof test optical fiber splices. 2. SCOPE This instruction manual ap ...

Page 2 of 4 3 Open the fiber clamps and mold. The protective tissues must be removed from the opened clamps before laying fiber into the recoater. 4 Hold the spliced fiber taut and lay the fiber across the recoater from left to right. Make sure the fiber is centered in the foam guides at the o ...

Page 3 of 4 7 Close the right fiber clamp and the mold The recoater will display a READY message when functioning properly. 8 Press the SET button to begin recoating the fiber. The screen will display an INJECTION message and then a UV COMPENSATIVE message while recoating. 9 Open the mold when ...

Page 4 of 4 11 When the proof test is complete, open the right fiber clamp first, and then open the left fiber clamp. 12 Carefully remove the fiber by lifting the fiber up from the right side first. Keep the fiber taut and straight when removing it from the recoater. 13 Use Isopropyl Alcohol ...