Front Runner RTTENT101 Setup Manual

Text of Front Runner RTTENT101 Setup Manual

Front Runner RTTENT101 FEATHER-LITE ROOF TOP TENT

SET-UP GUIDE RTTENT101 IMPORTANT WARNING! IT IS CRITICAL THAT ALL FRONT RUNNER RACKS AND ACCESSORIES BE PROPERLY AND SECURELY ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH TO YOU OR TO OTHERS. YOU ARE RESPONSIBLE FOR SECURING THE RACKS AND ACCESSORIES TO YOUR CAR, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTIN

Here's what you're looking at:

� Your new Feather-Lite tent, folded over, secured with velcro straps � 2 aluminum mounting channels � Hardware and fasteners (8 6mmx40 bolts, 8 6mm nuts, 8 washers, 8 8mm bolts, 8 slide plate washers, 4 mounting channel end caps, 4 self drilling sheet metal screws.) � The PVC zip cover � The ladder hinges and 2 bolts/nuts � Ladder � OPTIONAL Front Runner Slimline Rack Tent Mount Kit. (purchased

MAKE A CHOICE

Sometimes in life you have to ask yourself the difficult questions. Now is one of those times. WHICH WAY DO YOU WANT YOUR TENT TO OPEN? Over the side of the vehicle, with the ladder supporting the tent on the side of the vehicle? Or over the rear of the vehicle, with the ladder supporting the tent behind the vehicle? Since your Feather-Lite roof top tent is delivered to you with the option to be mounted to open out over the rear or to

For the majority of roof racks and load bars, the aluminum channels will face front to back

on the vehicle, parallel with the sides of your vehicle. So -- if you face the tent opening off the rear, the tips of the channels will face the opening and if your tent opens off the side, the opening of the tent will run parallel with the aluminum channels. Here’s how to tell which way your tent opens when it’s all folded up -- The nylon and velcro latc

•FYI• The bolt

heads will protrude slightly from the floor of the tent, but you’ll never notice since they will be under the mattress. A) Now that you know which way you want your tent to open, it’s time to attach the channels to the tent base. The channels will run front to back on the tent floor if your tent will be opening over the back of the vehicle. The channels will run side to side on the tent floor if your tent is

Front Runner RTTENT101 B) Fit the plastic end caps on each end of the mounting channels (it may

be necessary to use the rubber mallet to tap them into place). INSTALL LADDER AND COVER 1 A) Grab your helper friend and turn your tent over with the channels facing the ground. Be careful with the protruding bolts. You may need to prop up the tent using the channels. 5 A) Determine your roof carrier mounting points. • If you are mounting your tent to an old fashioned steel

C) Bolt on ladder, with ladder hinge plate on

the inside. D) INSTALL VINYL (PVC) COVER Slide blue retaining edge into sliding channel of tent base. Pull through until cover lines up with tent. Fold cover over tent and out of the way for placement of tent on the vehicle. MOUNT TENT ON VEHICLE If you’re using the Slimline Rack with the FRONT RUNNER SLIMLINE RACK TENT MOUNT KIT (FRTENT16), see TENT MOUNT KIT INSTALLATION GUIDE and mount your feet fir

Set up the tent once, and you’ll never have to think about it again!

OPEN YOUR TENT AND ADJUST THE LADDER 8 A) POP THE TENT If your PVC cover is on, loosen the black nylon straps and velcro corner tabs and then unzip around 3 edges. The cover can then be folded over and out of the way OR removed completely by sliding it out of the sliding track. 2. Slide the ladder out until the locking pins engage in the holes 3. Use the ladder as a lever to pull down

C) Insert the 6 steel rods to support the fly sheet.

The 2 longer rods are for the windows on each side. The 4 shorter front and rear rods mount into holes in the outer edge. Locate the eyelets in the Flysheet (in the middle of the sides, and on the corners of the front and back). The two center rods on each side slide into the tongue and groove aluminum extrusion between the floor boards. Practice inserting the rods by using two hands to create a cu

THE FINE PRINT: Now that your Front Runner Feather-Lite Roof Top Tent is installed, please be safe when getting in

and out of the tent. Take your time when backing out and make sure you have a firm footing on the ladder. And always remember- you've raised the height of your vehicle and changed the center of gravity - so use caution when entering parking structures and driving under other low hanging obstacles. Also use caution when taking tight tu

Front Runner Automobile Accessories Owners Instructions: